Epson Artisan EMP-830/EMP-835 Посібник з експлуатації - Сторінка 10
Переглянути онлайн або завантажити pdf Посібник з експлуатації для Програмне забезпечення Epson Artisan EMP-830/EMP-835. Epson Artisan EMP-830/EMP-835 11 сторінок. Epson operation guide monitor emp-830/emp-835
Друкувати сторінку
If a Projector Cannot be Monitored or Controlled Using EMP Monitor
Cause
Is the projector connected to
the network correctly?
Has the projector been set
up correctly for connection
to the network?
Has EMP Monitor been
installed to the computer
correctly?
Have all projectors that are
to be monitored and
controlled been registered in
the projector list?
Is the projector's "Standby
Mode" configuration menu
set to "Network ON"?
Remedy
Connect the network cable correctly.
s
"Network Cable
Connections" in the
User's Guide
Check the projector's network settings.
s
If using EMP-835
"Connecting in
Access Point Mode or Wired LAN Mode"
in the EasyMP Network Setup Guide
s
If using EMP-830
"Projector Network
Connecting Settings
(EMP-830)" in the
User's Guide
Uninstall EMP Monitor and then re-install
it.
Register the projector in the projector list.
s
p.3
In order to use EMP Monitor to monitor
and control the projector when it is in
standby mode, the projector's
"Extended" - "Standby Mode"
configuration menu must be set to
"Network ON".
s
"List of Configuration Menu
Commands" in the User's Guide
EMP Monitor Operation Guide
9