Epson LQ-860 - Impact Printer Бюлетень підтримки продукту - Сторінка 13

Переглянути онлайн або завантажити pdf Бюлетень підтримки продукту для Програмне забезпечення Epson LQ-860 - Impact Printer. Epson LQ-860 - Impact Printer 22 сторінки. For microsoft windows 3.0 and 3.1
Також для Epson LQ-860 - Impact Printer: Бюлетень підтримки продукту (20 сторінок), Бюлетень підтримки продукту (5 сторінок), Технічна довідка (7 сторінок), Інформація про продукт (8 сторінок), Бюлетень підтримки продукту (14 сторінок), Бюлетень підтримки продукту (25 сторінок), Бюлетень підтримки продукту (16 сторінок), Бюлетень підтримки продукту (18 сторінок), Бюлетень підтримки продукту (4 сторінок), Бюлетень підтримки продукту (7 сторінок), Бюлетень підтримки продукту (6 сторінок), Технічні характеристики (8 сторінок), Бюлетень підтримки продукту (11 сторінок)

EPSON

EPSON AMERICA, INC.

CENTRONICS PARALLEL REQUIREMENTS TO ELIMINATE RANDOM

Subject:

Date: 7/24/89

Page: 1 of 1

The self test can be run in draft mode or Letter Quality mode, depending on

which button is held down as the printer is turned on. With the color ribbon

cartridge installed, the self test prints in seven colors (black, magenta, cyan,

violet, yellow, red, and green).

yellow and blue combined to make green.

When a black ribbon is installed in the LQ-2550 and the self test is run,

some lines of the self test are printed in double-strike mode. The printer is

making the double passes for the color test, leaving a light and dark

appearance to the printout.

color ribbon is installed before printing is executed.

The self test can be performed using paper that is at least 8 - 1/2 inches

wide, but wide carriage paper is recommended.

To perform the self test, follow the instructions below:

1. The power cable is connected to a properly grounded electrical outlet.

2. The printer is turned off and the ribbon is installed.

3. While holding down the LINE FEED button (draft mode) or the FORM

FEED button (Letter Quality mode), turn on the printer. The printer will

beep three times and the POWER and PAPER OUT lights will turn on, if

paper is not installed in the printer,

4. Press the PAPER SELECT button until the type of paper desired is

selected.

5. Adjust the tractors or the paper guides to accommodate the size of the

paper being using.

6. Press the LOAD/EJECT button once, to automatically load the paper.

7. Press the ON LINE button, to start the self test.

8. A list of the printer's current settings is printed first, followed by a series

of characters. The self test continues until the paper runs out or until the

printer is reset.

9. Press the LOAD/EJECT button, to eject the paper, and turn the printer

Off.

10. After the printer is turned off, always wait at least 5 seconds before turning

it back on.

INFORMATION

Product Support Bulletin

Some colors require two passes, such as

The self test cannot detect whether a black or

PSB No: P-0048

Originator: ML