Dimplex Auvergne Log 2920 Інструкція з монтажу та експлуатації - Сторінка 3
Переглянути онлайн або завантажити pdf Інструкція з монтажу та експлуатації для Внутрішній камін Dimplex Auvergne Log 2920. Dimplex Auvergne Log 2920 4 сторінки. Focal point fire with optiflame elite incorporating 2kw fan heater
Друкувати сторінкуOperation
Open flap
for access to
controls
Thermostat
Fig.3
Fig.4
The controls are located behind the hinged ash pan flap (see
Fig.3).
A switch is in the 'ON' position when the red indicator mark of
the switch is visible.
Connect the fire to your electricity supply.
Flame Effect
Press switch
to the 'ON' position. The flame effect will now
operate.
Heating unit
You have a choice of low heat (1kW) or high heat (2kW) out
put.
Both settings have thermostat temperature control.
In order to operate the heating, switch
Position (see Fig.4).
Low heat setting
With switch
in the 'ON' position, press switch ' ' to 'ON'.
The 1 kW heat output is controlled by the thermostat, which
should be set to maximum (see 'Thermostat operation' ).
High heat setting
With switches
and ' ' in the 'ON' position, press switch ' '
to 'ON'.
The 2kW heat output is controlled by the thermostat, which
should be set to maximum (see 'Thermostat operation' ).
Thermostat operation
The thermostat controls the heat output according to the room
temperature. This ensures that the heater will not produce
heat unnecessarily when the room is warm.
To set the temperature you require, turn the thermostat knob
fully clockwise
to 'max' position. When the room is warm
enough, turn the knob back slowly until the thermostat just
clicks off. The heater will now maintain your selected
temperature.
Thermal safety cut-out
A thermal safety cut-out is incorporated in the heater to
prevent damage due to overheating.
This can happen if the heat outlet were restricted in any way.
The heater will switch on once the obstruction has been
removed and the heater has cooled. If the cut-out continues to
operate intermittently, the heater should be switched off and a
service agent contacted.
must be in the 'ON'