Epson PowerLite 737c Інформація про продукт - Сторінка 15

Друкувати сторінку

Epson PowerLite 737c Інформація про продукт

Projecting Wirelessly

Once you've started EasyMP and set up your projector and

computer in either ad hoc mode or access point mode, follow

these steps to start NS Connection and project wirelessly.

Note:

You must have installed EMP NS Connection from your projector

CD-ROM. See the User's Guide for installation instructions.

1. Make sure you've inserted the Epson 802.11 b/g card in the

projector's card slot (see page 10).

2. Windows: Select

EMP NS Connection

Start menu.

Macintosh OS X: Double-click the

icon in your Applications folder.

The first time you start NS Connection, you see a dialog

box asking you to select your network. Select the name

for your computer's wireless network adapter card and

click

Note:

If you don't see your network adapter's IP address, allow a

minute for it to appear. If your access point or AirPort base

station uses DHCP, sometimes it takes a minute for the server

to pick up the IP address.

You see the screen below. (If you have previously started

NS Connection, this is the first screen you see.)

from the Windows

EMP NS Connection

2/05

Epson PowerLite 737c Projector

Note:

Once you've selected the IP address for your network adapter,

you won't see the Switch network dialog box when you start

NS Connection. If you want to change to a different network

adapter, click

Extension

box, then click

Switch LAN

If the connection is working properly, you see your

projector listed. If you have additional Epson projectors on

the network, they are also listed, along with their status.

The color of the status icon next to each projector's name

indicates its status:

❏ Gray: the projector is not connected

❏ Orange: the projector is connected to another

computer

❏ Green: the projector is connected to your computer

3. If you don't see your projector, check the following:

❏ Make sure your wireless signal is strong enough to

establish a connection. If you have a Macintosh, check

the AirPort icon on the Macintosh menu bar. For

Windows, see the documentation for your access point

or computer network card.

❏ Make sure you're trying to connect to the right

network. In Windows, verify that you've enabled your

computer's connection to the access point or that your

wireless card or adapter is enabled, and that its SSID

matches the projector's ESSID. In Macintosh, check

the AirPort status menu (click the AirPort icon on your

menu bar) to make sure AirPort is turned on and the

projector's ESSID or your AirPort network is selected.

Remember that the ESSID is case-sensitive.

❏ Make sure you aren't projecting one of the EasyMP

configuration screens. (You should see a message that

the projector is ready to connect.) If you have to exit

the configuration screen, restart NS Connection.

❏ Check the IP address for both your projector and your

wireless card, adapter, access point, or AirPort base

station. The first three sections of the IP address should

be identical. The last section of the projector's IP

address should be close, but not identical, to the last

section of the IP address for your wireless interface,

access point, or base station.

❏ Restart your computer and start NS Connection again.

❏ If you still don't see your projector and you are using

access point mode, follow the instructions in

"Connecting in IP Connect Mode" on page 16 to

connect to the projector manually.

❏ Make sure you have disabled any firewall software.

Epson PowerLite 737c Projector

on the EMP NS Connection dialog