Toshiba 21J1H Схематична діаграма

Переглянути онлайн або завантажити pdf Схематична діаграма для ТЕЛЕБАЧЕННЯ Toshiba 21J1H. Toshiba 21J1H 12 сторінок. Color television
Також для Toshiba 21J1H: Посібник з експлуатації (32 сторінок)

Друкувати сторінку

SCHEMATIC DIAGRAM

MODEL : 21CJ1R/21J1E/21J1ES/21J1H/21J1M/21J1MJ/21J1T

WARNING: BEFORE SERVICING THIS CHASSIS, READ THE "X-RAY RADIATION PRECAUTION", "SAFETY

PRECAUTION" AND "PRODUCT SAFETY NOTICE" ON THE MANUAL FOR THIS MODEL.

CAUTION: The international hazard symbols "

which have special characteristics important for safety and should be replaced only with types identical to those in the

original circuit or specified in the parts list. The mounting position of replacements is to be identical with originals.

Before replacing any of these components, read carefully the PRODUCT SAFETY NOTICE on the MANUAL for this

model. Do not degrade the safety of the receiver through improper servicing.

NOTE:

1. RESISTOR

Resistance is shown in ohm [K = 1.000, M = 1.000.000]. All resistors are 1/6W and 5% tolerance

carbon resistor, unless otherwise noted as the following marks.

1/2R = Metal or Metal oxide of 1/2 watt

1RF = Fuse resistor of 1 watt

K =

10%

2. CAPACITOR

Unless otherwise noted in schematic, all capacitor values less than 1 are expressed in F, and

the values more than 1 in pF.

All capacitors are ceramic 50V, unless otherwise noted as the following marks.

3. The parts indicated with "

4. Voltages read with DIGITAL MULTI-METER from point indicated to chassing ground, using a color bar signal with

all controls at normal, line voltage at 220 volts.

5. Waveforms are taken receiving color bar signal with enough sensitivity.

6. Voltage reading shown are nominal values and may vary

SCHEMATIC DIAGRAM STRUCTURE:

– MAIN / CRT DRIVE Circuit .............................................................................................................. 1/2

– POWER Circuit .................................................................................................................................. 2/2

" in the schematic diagram and the parts list designate components

G =

F =

Electolytic capacitor

" have special characteristics, and should be replaced with identical parts only.

– 31 –

1/2S = Carbon compsistion of 1/2 watt

10W = Cement of 10 watt

Mylar capacitor

20% except H.V.