Toshiba VTV21FL3 Інструкція з експлуатації Посібник з експлуатації - Сторінка 37
Переглянути онлайн або завантажити pdf Інструкція з експлуатації Посібник з експлуатації для ТЕЛЕБАЧЕННЯ Toshiba VTV21FL3. Toshiba VTV21FL3 40 сторінок. Combination 21" flat color television and video cassette recorder
BEFORE REQUESTING SERVICE
If your TV/VCR does not work properly check the following before calling a service engineer.
SYMPTOM
POWER
The Mains lead is not connected.
No power.
Main power switch is OFF.
TIMER REC buttons are ON.
(TIME REC indicator is on.)
Recorder does not work
even though STANDBY.
Moisture condensation has formed inside
recorder.
TV BROADCAST RECEPTION
The Mains lead is disconnected.
Antenna connector is not connected or wires
are broken.
No picture, no sound.
ON/STANDBY button is off.
Possibly station trouble.
Possibly station trouble.
Antenna conector is not connected or wires
Sound OK, poor picture.
are broken.
Possibly local interference.
Possibly station trouble.
Picture OK, poor sound.
Possibly local interference.
Volume control set at minimum position.
Antenna connector is not connected or wires
are broken.
Poor reception.
Possibly station trouble.
Antenna connector is not connected or wires
are broken.
Possibly station trouble.
Poor color or no color.
Possibly local interference.
Color control is not adjusted.
RECORDING
Protection tab on the cassette tape has been
Recording does not work.
removed.
Main power switch is OFF.
Clock is not set.
START/END time is not correctly.
Timer recording does not
work.
TIMER REC buttons are OFF.
Present time is not set correctly.
One-Touch Timer Recording (OTR) is ON.
INDEX mark was not
INDEX mark was recorded at the beginning
registered.
of the tape.
5960101A/E/33-back
CAUSE
Connect Mains lead to AC outlet.
Set it to ON.
Set them to OFF.
(TIME REC indicator is off.)
Wait for a few hours.
Connect the Mains lead to the AC outlet.
Check Antenna connections or broken wires.
Press the ON/STANDBY button.
Try another channel.
Try another channel.
Check Antenna connections or broken wires.
Move the Antenna away from the source of
interference.
Try another channel.
Move the Antenna away from the source of
interference.
Increase VOLUME control.
Check Antenna connections or broken wires.
Try another channel.
Check Antenna connections or broken wires.
Try another channel.
Move the Antenna away from the source of
interference.
Press the CANCEL button.
Place an adhesive tape over the gap.
Set main power to ON.
Set the clock.
Set the START/END time correctly.
Set the TIMER REC buttons to ON.
Set the present time correctly.
After OTR recording, set the timer recording.
Let the tape run for a couple of seconds
before recording the first INDEX mark.
35
SOLUTION
PAGE
4
4
26
2
4
7
4
13
13
7
37
13
37
13
7
13
7
13
37
15
19
4
12
25/26
26
12
29
32
35
28/5/01, 1:39 PM