MSI 612BF Посібник користувача - Сторінка 30
Переглянути онлайн або завантажити pdf Посібник користувача для Материнська плата MSI 612BF. MSI 612BF 48 сторінок. 3d-agp vga / 3d-audio m/b for socket 370
Також для MSI 612BF: Посібник (45 сторінок)
Друкувати сторінку
Video Off Method:
V/H SYNC+Blank
Blank Screen
DPMS
Video Off In Suspend : This determines the manner in which the monitor is blanked.
The choice: Yes, No.
Suspend Type: Select the Suspend Type.
The choice: PWRON Suspend, Stop Grant.
MODEM Use IRQ: This determines the IRQ in which the MODEM can use.
The choice: 3, 4, 5, 7, 9, 10, 11, NA.
Suspend Mode: When enabled and after the set time of system inactivity, all devices
except the CPU will be shut off.
The choice: Enabled, Disabled.
HDD Power Down: When enabled and after the set time of system inactivity, the hard disk
drive will be powered down while all other devices remain active.
The choice: Enabled, Disabled.
Soft-Off by PWRBTN: Pressing the power button for more than 4 seconds forces the
system to enter the Soft-Off state when the system has "hung."
The choice: Delay 4 Sec, Instant-Off.
CPU THRM-Throttling: Select the CPU THRM-Throttling rate , this function work when
select the temperature value in "CPU Warning Temperature" under " PC Health
Status" ,when the rate choose 50% the CPU only work 50% of excute instruction and 50%
of idle in a periode of time it will derease the temperature of CPU
The choice: 25.0%, 37.5%, 50.0%, 62.5%, 75.0%, 87.5%.
Power on by ring : When you select Enabled, a signal from ring returns the system to Full
On state.
Resume on by alarm : When you select Enabled, the following fields appear. They let you
set the alarm that returns the system to Full On state.
The choice: Enabled, Disabled.
Reload Global Timer Events: Timer events are I/O events whose occurrence can prevent
the system from entering a power saving mode or can awaken the system from such a
mode. In effect, the system remains alert for anything which occurs to a device which is
configured as Enabled , even when the system is in a power down mode.
Primary IDE 0
Primary IDE 1
Secondary IDE 0
Secondary IDE 1
FDD, COM, LPT Port
the ranges are from 1 min. to 1 hr. except for HDD Power Down which
ranges from 1 min. to 15 min. and disable.
This determines the manner in which the monitor is blanked.
This selection will cause the system to turn off the vertical and horizontal
synchronization ports and write blanks to the video buffer.
This option only writes blanks to the video buffer.
Initial display power management signaling.
27
.