Epson RX500 - Stylus Photo Color Inkjet Інструкція з експлуатації

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Програмне забезпечення Epson RX500 - Stylus Photo Color Inkjet. Epson RX500 - Stylus Photo Color Inkjet 4 сторінки. Product support bulletin(s)
Також для Epson RX500 - Stylus Photo Color Inkjet: Посібник користувача (15 сторінок), Посібник користувача (20 сторінок), Інформаційний листок продукту (4 сторінок), Технічні характеристики (2 сторінок), Посібник "Почніть тут (9 сторінок), Посібник з налаштування (2 сторінок), Посібник користувача (12 сторінок), Оновлення (1 сторінок), Бюлетень підтримки продукту (6 сторінок), Бюлетень підтримки продукту (1 сторінок)

Instructional Manual Continuous Ink System for use in Epson

R200/R210/R220/R300/R310/R320/R340/RX600 RX500/RX510/RX620

Before using this product, please read and follow the instructions. After opening your package, make sure to check

that all the accessories shown in figures 1-1 through 1-3 below are enclosed.

Conduct Parts Check:

1. Accessories

a. Continuous Ink System (1) b. Air breather plugs (6) c. T shape Adhesive Pad (1) d. Syringe (1)

Fig. 1-1

2. Set-Up Continuous Ink System (CIS)

a. Before installation, lay out all your parts in front of your printer.

b. Check your system for any leakage, and make sure your tubing system is tightly connected and straight.

c. Place the CIS ink tank on the same horizontal level as printer, The ink tank has two chambers per color, the front

chamber is to hold the ink and the rear chamber is to control the flowing pressure.

chamber contains only a small amount of inks(as little as possible). The ink should reside in the front chamber.

sure the ink tank plugs are tightly closed, tilt the ink tank forward to make the majority of the ink flow into the front

chamber if the rear chamber has some excess ink. (Fig. 2-1 through Fig. 2-3).

d. Place the CIS on the right hand side of the printer as shown (Fig. 2-4) and keep it on the same level surface

as the printer.

e. Hold down the ink tank with one hand and remove the original shipping plugs as shown, make sure to save these for

later use (Fig.2-5).

f. Install the Air Breather widest end first, into the ink reservoir tank making a snug fit however make sure not to push

them in to tight as it could crack the tank (Fig.2-6). Also make sure when removing the air breathers from the tank

that this is also done carefully to avoid cracking the tank.

Caution: Make sure not to push the breathers too tight as it could crack the tank. Also when removing the air breathers

from the tank use caution to avoid cracking.

Fig 2-1

Fig. 1-2

Fig 2-2

Fig. 1-3

It is important that the rear

Fig 2-3

Make