Before switching on the television put your decoder and media recorder to Standby if they are connected and ensure the
aerial is connected to your television. To set up the television, use the buttons on the remote control as detailed on page 7.
IMPORTANT: Ensure that the aerial or cable is
connected and a Common Interface module is not
inserted before switching on the TV for the fi rst time
installation.
1.
Connect the mains plug and switch the TV on using
the side standby switch. Then the initial setup wizard
will be displayed. This wizard will appear the fi rst time
that the television is switched on and each time the
television is reset.
Welcome to use the Wizard for Initial Setup!!
Please press [OK] to start the wizard.
2.
Press the OK button to start the wizard.
3.
Select your preferred language by pressing the
button, then press OK or
4.
Select your country by pressing the
press OK or
to enter the next step.
Note: If you select France or Italy, you will be asked to
set a password. Use the digit buttons to enter a
four-digit number for your password. (0000 is too
simple to be set as your password.) Re-enter the
same code to confi rm the password. After that,
you will enter the next step automatically. (At this
step, you can only press the
the previous step.)
5.
Select your location by pressing the
then press OK or
to enter the next step. The location
options include Home and Retail.
Select Home and press OK to enter the next step. Use
the
or
button to select your Tuner mode Antenna
or Cable.
Select Antenna.
• Press OK or
to enter.
• Press
or
to select a scan type
Digital&Analogue, Digital or Analogue and press
OK or
to enter the next step.
• Press
or
to select Scan or Skip Scan,
Select Scan, then press OK or
searching for all available channels.
Select Cable.
• Press OK or
to enter.
• Press
or
to select a scan type
Digital&Analogue, Digital or Analogue and press
OK or
to enter the next step.
• Press
or
to select Scan or Skip Scan,
Select Scan, then press OK or
step.
• Select Full if available to search for and store all
available channels.
• You may select Advanced, then confi gure proper
cable information such as Frequency, Modulation,
symbol rate and Network ID. Use the digit buttons
Initial Installation
or
to enter the next step.
or
button, then
button to return to
or
button,
to automatically start
to enter the below
English - 12 -
to input the values of frequency, symbol rate and
network ID; use the
modulation mode.
• Press OK to start initial setup for all available
channels.
Note: The searching progress bar will move along the
line. You must allow the television to complete
the search. During the search, pressing EXIT
will interrupt the search halfway and go back to
the previous step.
6.
You can also skip the initial setup process by selecting
Skip Scan.
7.
During the setup, you can follow the hints available at
the bottom of the screen to return to the previous step
by pressing the
button.
8.
After the initial setup fi nishes, press OK to display the
channel list.
or
button to select a
Друкувати сторінку