Epson Stylus Pro 7600 Посібник з розпакування та налаштування - Сторінка 15
Переглянути онлайн або завантажити pdf Посібник з розпакування та налаштування для Програмне забезпечення Epson Stylus Pro 7600. Epson Stylus Pro 7600 24 сторінки. W 24-inch-wide and 44-inch-wide photographic
printers with new seven-color ultrachrome ink system
Також для Epson Stylus Pro 7600: Посібник (5 сторінок), Короткий довідник (11 сторінок)
Друкувати сторінку
Setting up Stylus Pro 7600/9600
Connecting the power cord
1. Make sure that the printer is off. It is off when
the surface of the Power button is even with
the button protectors.
2. Connect the power cord to the AC inlet on the
back of the printer.
3. Route the power cord through the clamps at
the rear of the printer. The cord can be routed
to either the left or right side.
4. Check the label on the back of the printer to
make sure the voltage required by the printer
matches that of the electrical outlet you are
using.
5. Plug the power cord into a properly grounded
electrical outlet.
c
Caution:
Do not use an outlet that is controlled by an
automatic timer or wall switch. Otherwise,
accidental shut down or damage to your
printer may occur.
Installing the ink cartridges
To install the ink cartridges, follow the
instructions below.
w
Warnings:
The ink cartridges are self-contained units.
Under ordinary use, ink will not leak from the
cartridges. If ink does get on your hands, wash
them thoroughly with soap and water. If ink gets
into your eyes, flush them immediately with
water.
1. Turn on the printer by pressing the Power
button. After a short time NO INK CARTRIDGE
is displayed on the LCD panel.
2. Open the ink compartment cover, and make
sure that the ink lever is in the up position.
3. Remove the package from an ink cartridge.
13