Philips AZ 1605 Посібник користувача - Сторінка 7

Переглянути онлайн або завантажити pdf Посібник користувача для Стереосистема Philips AZ 1605. Philips AZ 1605 48 сторінок. Cd soundmachine with dynamic bass boost
Також для Philips AZ 1605: Технічні характеристики (2 сторінок), Технічні характеристики (2 сторінок), Технічні характеристики (2 сторінок)

POWER SUPPLY

Batteries

For the set (optional)

Open the battery compartment of the set and insert 6 batteries,

type R20, UM1 or D-cells (preferably alkaline).

Remove batteries if they are flat or the set is not going to be used

for a longer period of time.

Batteries contain chemical substances, so they should be

disposed of properly.

AC power supply

1 Check whether the power supply as shown on the type plate

corresponds to your local power supply. If it does not, consult

your dealer or service organization. The type plate is located

on the bottom side of the set.

2 If the set is equipped with a VOLTAGE selector X, set this

selector to the local power supply.

3 Connect the power cord to the AC MAINS inlet and the wall

outlet. This switches on the power supply. The power cord is

inside the battery compartment.

The battery AC power supply will be switched off when the set is

connected to the mains. To change over to battery supply,

withdraw the plug from the unit's AC MAINS inlet.

To disconnect the set from the power supply completely, remove

the power plug from the wall outlet.

The set complies with the FCC-Rules, Part 15 and with 21 CFR 1040.10.

Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and

2. This device must accept any interference received, including interference that may cause

undesired operation.