CONNECTIONS AND CONTROLS
&
BACK PANEL
& Telescopic aerial – improves FM reception
* Battery compartment – for 6 batteries,
type R-20, UM1 or D-cells
( Voltage selector (inside battery compartment,
some versions only) – adjust to match the local voltage 110/220V before
plugging in the set
) p – 3.5 mm stereo headphone socket
Note: The speakers will be muted when headphones are connected to
the set.
¡ AC MAINS – inlet for mains lead
POWER SUPPLY
Whenever convenient, use the power supply to conserve battery life. Make
sure you remove the power plug from the set and wall outlet before
inserting batteries.
Batteries (not included)
• Insert 6 batteries, type R-20, UM-1 or D-cells, (preferably alkaline)
with the correct polarity.
Remote control (for AZ2045 only)
• Insert 2 batteries, type AAA, R03 or UM4 (preferably alkaline).
Incorrect use of batteries can cause electrolyte leakage and will corrode
the compartment or cause the batteries to burst.
• Do not mix battery types: e.g. alkaline with carbon zinc. Only use
batteries of the same type for the set.
• When inserting new batteries, do not try to mix old batteries with the
new ones.
• Batteries contain chemical substances, so they should be
disposed of properly.
For more information on operation instruction please visit Philips Audio internet site :
http://www.audio.philips.com
3 - 2
*
(
)
6 x R20 • UM-1 • D-CELLS
¡
Using AC Power
1 Check if the power supply, as shown on the type plate located on the
bottom of the set, corresponds to your local power supply. If it does
not, consult your dealer or service centre.
2 If your set is equipped with a voltage selector, adjust the selector so
that it matches with the local mains.
3 Connect the mains lead to the wall socket.
4 To disconnect the mains supply, unplug the set from the wall socket.
Auto-Standby mode
When a CD or tape has reached the end of playback and remains in the
stop position for more than
15 minutes, the set will switch off automatically to save power.
Друкувати сторінку