Philips AZ 2425 Посібник користувача - Сторінка 8

Переглянути онлайн або завантажити pdf Посібник користувача для Стереосистема Philips AZ 2425. Philips AZ 2425 50 сторінок. Cd radio cassette recorder
Також для Philips AZ 2425: Технічні характеристики (2 сторінок), Технічні характеристики (2 сторінок)

Друкувати сторінку

POWER SUPPLY

BATTERIES

Whenever convenient, use the AC power supply if you want to

conserve battery life. Make sure you remove the power plug

from the set and wall outlet before inserting batteries.

Batteries (optional)

1. Open the battery compartment and insert as shown six

batteries, type R20, UM1 or D-cells (preferably alkaline) with

the correct polarity as indicated by the (

inside the compartment.

• Remote control batteries (included)

Open the battery compartment and insert as shown two

batteries, type R03, UM4 or AAA (preferably alkaline).

2. Replace the compartment door, making sure the batteries are

firmly and correctly in place. The set is now ready to operate.

3. Remove the batteries if exhausted or if they will not be used

again for a long period.

The incorrect use of batteries can cause electrolyte leakage and

will corrode the compartment or cause the batteries to burst.

Therefore:

– Do not mix battery types, e.g. alkaline with zinc carbonate.

– When inserting new batteries, replace all batteries at the

same time.

All kinds of batteries contain chemical substances

therefore they should be disposed of properly.

POWER

1. Check if the power voltage as shown on the type plate (on the

base of the set) corresponds to your local power voltage. If it

does not, consult your dealer or service organization.

2. Connect the power cord (packed inside the battery

compartment) to the MAINS ~ outlet and the wall outlet.

™ The set is now ready to use.

3. To switch off the power supply completely, pull the power

plug out of the wall outlet.

Note: If the set is connected to the power and in the POWER off

position, a very small amount of power, 2 Watts, will be

drawn from the power supply.

POWER SAVING BACKLIGHT DISPLAY

• The lighting of the display only functions if the set is

connected to the power supply.

and (

symbols

6 x D-cells - R20 - UM1

SPEAKER

–