Toshiba CO60PM Посібник користувача - Сторінка 26

Переглянути онлайн або завантажити pdf Посібник користувача для DVD-плеєр Toshiba CO60PM. Toshiba CO60PM 28 сторінок. Upscaling dvd player with divx

Друкувати сторінку

1. Connecting to a Display

Others

Before Calling Service Personnel

Check the following guide for the possible cause of a problem before contacting service.

Symptoms and correction

Symptom

No power.

The DVD player turned off

by itself.

No picture.

No sound.

The playback picture has

occasional distortion.

Brightness is unstable or

noises are present in the

playback pictures.

The DVD player does not

start playback.

Playback does not follow

the course of the disc's

program.

Buttons do not work.

The remote control does

not work properly.

Cause

• The power plug is disconnected.

• The automatic power off function turned

the unit off.

• The TV is not set to receive DVD signal

output.

• The video/HDMI cable is not connected

securely.

• Mismatch setting between TV and this unit. • Select the correct Video out setting.

• Wrong connection.

• The equipment connected with the audio

cable is not set to receive DVD signal

output.

• The audio cable is not connected securely. • Connect the audio cable securely into the

• The audio receiver or TV is turned off.

• The setting of output sound format is

incorrect.

• The disc is dirty.

• It is in fast forward or fast reverse playback. • Sometimes a small amount of picture distortion

• The effect of copy protection.

• No disc is inserted.

• An unplayable disc is inserted.

• The disc is placed upside down.

• The disc is not placed within the guide.

• The disc is dirty.

• The parental lock function is set.

• It is in the mode of repeat playback, memory

playback, etc.

• Power supply fluctuations or other

abnormalities such as static electricity may

interrupt correct operations.

• The remote control is not pointed at the

remote sensor of the DVD player.

• The remote control is too far from the DVD

player.

• The batteries in the remote control are

exhausted.

Correction

• Connect the power plug securely into the wall outlet.

• Press the PLAY button.

• Select the appropriate video input mode on the

TV so the picture from the DVD player appears

on the TV screen.

• Connect the video/HDMI cable securely into the

appropriate jacks.

• Check the connection.

• Select the correct input mode of the audio receiver

so you can listen to the sound from the DVD

player.

appropriate jacks.

• Turn on the equipment connected with the audio

cable.

• Select the proper audio setting.

• Remove the disc and clean it.

may appear. This is not a malfunction.

• Connect the DVD player directly to the TV. Avoid

connecting the DVD player to a VCR or TV/VCR

combination.

• Insert a disc.

• Insert a playable disc. (Check the disc type and

colour system.)

• Place the disc with the playback side down.

• Place the disc correctly inside the guide on the

disc tray.

• Clean the disc.

• Cancel the parental lock function or change the

parental lock level.

• These operations may prevent a proper progress

of the contents.

• Press and hold the ON/STANDBY button on the

front panel for more than about 3 seconds. The

DVD player turns off. Press the button again

to turn it on. If the buttons still do not work,

disconnect the power plug and insert it into the

wall outlet again.

• Point the remote control at the remote sensor of

the DVD player.

• Operate the remote control within about 7 m.

• Replace the batteries with new ones.

Page

15-16

15-