Toshiba TDP-MT500 Посібник користувача - Сторінка 26
Переглянути онлайн або завантажити pdf Посібник користувача для Проектор Toshiba TDP-MT500. Toshiba TDP-MT500 42 сторінки. Home projector
Також для Toshiba TDP-MT500: Посібник користувача (40 сторінок)
Друкувати сторінку
VIEWING COMPUTER IMAGES
Main power switch
TELE
MENU/EXIT
POWER
LAMP
TEMP
POWER button
Note-book type computer
When the projector is connected to a note-book type computer, the picture images from the computer may
not be projected on screen. On this occasion, setup the computer so that it may output picture signals. How
to setup the computer depends on the type of the computer. Refer to the instruction manual of the
computer.
Example of setup for the external output:
Press "Fn" key and any of "F1" to "F12" key (Depends on the type of the computer).
26
WIDE
ENTER
POWER button/
POWER indicator
POWER ON/OFF
SOURCE
DVI
C1
C2
D
COMP1
COMP2
DVI-D
DVI
S
V
A
S-VIDEO
VIDEO
DVI-A
16:9
4:3
ZM
16:9
4:3
ZOOM
REAL
DYN
REAL
DYNAMIC
ASPECT
2
3
1
ENTER
MENU
EXIT
CNT
BRI
COL
TIN
CONTRAST BRIGHT
COLOR
TINT
TEM
GAM
SH
COLOR
GAMMA SHARPNESS
TEMP
LIGHT
LIGHT
When stopping projection:
8 Press POWER ( ) button.
•
A confirmation message appears on the screen.
•
To cancel this state, wait for a while, or press EXIT but-
ton or MENU button of the remote controller, or press
MENU/EXIT button of the projector.
9 Press POWER ( ) button again.
•
The light-source lamp comes off and the projector comes
to standby state. At this time POWER indicator blinks in
orange.
10 Wait about 2 minutes until POWER
indicator comes on in orange.
•
Wait about 2 minutes in standby state, because during
this time the intake/exhaust fan is turning to cool down
the light-source lamp.
•
The intake/exhaust fan continues to turn for about one
minute after POWER indicator has come on in orange.
•
Do not turn off the main power switch while POWER in-
dicator is blinking. If the main power switch is turned off
immediately after use, the projector may fall in failure.
•
The fan generates a loud sound while cooling down, but
it is not a failure.
11 Turn "OFF" the main power switch
(Turn to indication O).
•
When the projector is not used for a long time, unplug
the power plug from the power outlet for safety.
•
Set the lens cap to prevent dust from being gathered
from outside.