Toshiba TDP-MT700 Посібник користувача - Сторінка 34
Переглянути онлайн або завантажити pdf Посібник користувача для Проектор Toshiba TDP-MT700. Toshiba TDP-MT700 36 сторінок. Home theater projector
Також для Toshiba TDP-MT700: Посібник користувача (34 сторінок), Посібник з експлуатації (49 сторінок)
Друкувати сторінку
Troubleshooting
Problem
The
projector
does not
turn on.
No picture.
Image is
unstable.
Picture is
blurred.
Remote
control does
not work
correctly
34
Additional information
Cause
There is no power from the
power cord.
The power switch is not in the
ON position.
Attempting to turn the projector
on again during the cooling
process.
The lamp cover is not securely
attached.
The video source is not turned
on or connected correctly.
The projector is not correctly
connected to the input source
device.
The input signal has not been
correctly selected.
The connection cables are not
securely connected to the
projector or the signal source.
The projection lens is not
correctly focused.
The projector and the screen
are not aligned properly.
The lens cap is still attached to
the lens
The batteries are out of power.
There is an obstacle between
the remote control and the
projector.
You are too far away from the
projector.
Remedy
Plug the power cord into the AC inlet
on the rear of the projector, and plug
the power cord into to a power outlet. If
the power outlet has a switch, make
sure it is switched on.
Put the power switch in the ON
position.
p. 20
Wait until the cooling-down process is
completed.
Correctly attach the lamp cover.
Turn the video source on and check
that the signal cable is connected
correctly.
p. 18
Check the connection.
Select the correct input signal with the
INPUT buttons on the remote control or
INPUT on the projector.
Correctly connect the cables to the
appropriate terminals.
Adjust the focus of the lens using the
focus ring.
p. 21
Adjust the projection angle and
direction as well as the height of this
unit if necessary.
p. 21
Remove the lens cap.
Replace both of the batteries with new
ones.
p. 11
Remove the obstacle.
Stand within 8 meters (26.2 feet) of the
projector.
p. 13
p. 20
p. 31
p. 18
p. 20
p. 18
p. 20
p. 13