Toshiba TDP-S25 Посібник користувача - Сторінка 18

Переглянути онлайн або завантажити pdf Посібник користувача для Проектор Toshiba TDP-S25. Toshiba TDP-S25 25 сторінок. Dlp data projector 1800 ansi lumens
Також для Toshiba TDP-S25: Посібник користувача (25 сторінок), Технічні характеристики (2 сторінок)

Друкувати сторінку

Using the document camera

Please read this chapter if the model you purchased is TDP-SC25 which includes a

document camera.

How to use the document camera

Using the camera attached on the projector

Status before preparation

1) Set up arm.

(When stored)

3) Raise camera head.

PRECAUTIONS

• For camera interconnection, be sure to use the supplied RGB cable (25 cm or 3 m). If you

use the other cables, the normal operation may not be achieved and even the malfunction

may result.

• When moving the projector with the camera attached, do not grab the camera arm and/or

the camera head.

• When moving the projector with the camera attached, first ensure that the camera is securely

locked in position on the tray.

• Insert the RGB cable straight and securely until it is fixed in place.

• Do not jolt or force the camera head or camera arm. Doing so could cause malfunction.

• Note that when extending or rotating the camera arm, the arm moves in an arc. Take care

not to bump yourself or others with it.

• When placing the projector in the carrying bag, remove the connection cables. Otherwise,

damage to the connectors and cables may result.

2) Rotate arm.

Using the camera removed from the projector

Status before preparation

1) Disconnect the RGB

(When stored)

cable, then slide the

lock switch to release

lock.

3) Remove the document

4) Extend the tip resistant

camera from the tray.

bars to set the

Pull up toward direction q

document camera.

PRECAUTIONS

• Installation of the document camera onto the tray should be performed in the reverse

order shown above.

• When replacing the document camera on the tray, ensure that the lock lever is securely

locked in position.

• When using the tip resistant bars, pull them fully until each forms the angle of 90 degree.

If you don't use the bars, the camera may topple over.

2) While pushing the lock

lever in the arrow

direction, lift up the

document camera.

5) Connect the document

camera and the

projector using the

supplied RGB cable.