Toshiba TDP-S8UC01 Посібник користувача - Сторінка 26

Переглянути онлайн або завантажити pdf Посібник користувача для Проектор Toshiba TDP-S8UC01. Toshiba TDP-S8UC01 45 сторінок. Data projector

Projector placement angle adjustments

The placement angle and the height of the projected image can be adjusted by the foot

adjuster.

 Lift up the front of the projector to

the desired angle, then press the

foot adjuster release button.

The foot adjuster extends. Release the but-

ton to lock the position.

 To adjust the horizontal angle, use

the tilt adjuster.

To stow the foot adjuster, hold up the projector

while pressing the foot adjuster release button,

then slowly lower the projector.

Adjusting the screen size and focus

 Use the zooming lever to adjust the screen size.

 2 Use the focusing ring to adjust the focus.

Notes

• Note that a lamp characteristics may rarely cause the brightness to ﬂuctuate slightly.

• A lamp is consumable item. If used for extended periods, images will appear dark, and

the lamp could burn out. This is characteristic of a lamp, and is not malfunction. (The

lifetime of the lamp depends on conditions of use.)

• The DMD

is made using extremely advanced technology, but there may be black

spots (pixels that do not light) or bright spots (pixels that are constantly lit) on the panel.

Please note that these are not malfunctions.

• Although this projector supports a wide range of RGB signals

supported by this projector (SVGA) will be expanded or shrunk, which will affect image

quality slightly. To view high-quality images, it is recommended that the computer's

external output should be set to SVGA resolution.

• With some models of computer having LCD displays or the like, displaying images

simultaneously on the projector and the monitor's display may prevent the images from

displaying properly. If this happens, turn off the computer's LCD display. For information

on how to turn off the LCD display, see the owner's manual of your computer.

• If no signal is being input from the connected equipment or signal input is stopped while

projecting, the "No signal" will appear.

• If a signal not supported by the projector is input, the "Unsupport signal" will appear.

• If an unavailable operation button is pressed, the

p.42

icon will appear.

, any resolutions not