Toshiba TDP-S9 Посібник користувача - Сторінка 24

Переглянути онлайн або завантажити pdf Посібник користувача для Проектор Toshiba TDP-S9. Toshiba TDP-S9 43 сторінки. 0.55" dmd dlp
Також для Toshiba TDP-S9: Технічні характеристики продукту (1 сторінок), Посібник з експлуатації (39 сторінок)

Projector placement angle adjustments

The placement angle and the height of the projected image can be adjusted by the foot

adjuster.

Lift up the front of the projector to

the desired angle, then press the

foot adjuster release button.

The foot adjuster extends. Release the

button to lock the position.

To adjust the horizontal angle, use the

tilt adjuster.

To stow the foot adjuster, hold up the projector while

pressing the foot adjuster release button, then slowly

lower the projector.

Adjusting the screen size and focus

Use the zooming lever to adjust the screen size.

Use the focusing lever to adjust the focus.

Adjusting the volume with the remote

control's Volume

The speaker volume can be adjusted when an audio signal is being input.

Notes

• Note that a lamp characteristics may rarely cause the brightness to fluctuate slightly.

• A lamp is consumable item. If used for extended periods, images will appear dark, and the lamp could

burn out. This is characteristic of a lamp, and is not malfunction. (The lifetime of the lamp depends on

conditions of use.)

• The DMD

is made using extremely advanced technology, but there may be black spots (pixels that

do not light) or bright spots (pixels that are constantly lit) on the panel. Please note that these are not

malfunctions.

• Although this projector supports a wide range of RGB signals

this projector (SVGA) will be expanded or shrunk, which will affect image quality slightly. To view high-

quality images, it is recommended that the computer's external output should be set to SVGA (800 ×

600) resolution.

• With some models of computer having LCD displays or the like, displaying images simultaneously on

the projector and the monitor's display may prevent the images from displaying properly. If this happens,

turn off the computer's LCD display. For information on how to turn off the LCD display, see the owner's

manual of your computer.

• If a signal not supported by the projector is input, the "For best image quality, lower image resolution.

" or "For best image quality, refresh rate." will appear.

• If no signal is being input from the connected device, the "Searching for source" will appear.

Volume

buttons

, any resolutions not supported by

p.40