Toshiba TDP-XP1U - XGA DLP Projector Посібник користувача - Сторінка 20
Переглянути онлайн або завантажити pdf Посібник користувача для Проектор Toshiba TDP-XP1U - XGA DLP Projector. Toshiba TDP-XP1U - XGA DLP Projector 48 сторінок. Tdp-xp1u user's guide
Друкувати сторінку
Preparing and using the remote control
■ Loading a coin cell battery
into the remote control
j Remove the battery holder.
Hold down the side release firmly and pull
out the battery holder.
k Load a coin cell battery (CR2025).
Be sure to align the plus and minus ends
of the battery properly.
l Replace the battery holder back
into the remote control.
Coin cell battery
• Before using the battery, be sure to observe the Safety Precautions described in previous
pages.
• Remove the battery from remote control when not using for extended periods.
• If the remote control stops working, or if its range decreases, replace the battery with a
new one.
• Keep the battery away from the reach of children. Battery is choking hazard and can
be very dangerous if swallowed. If the battery is swallowed, seek medical assistance
immediately.
The remote control
• The remote control may fail to operate if the infrared remote sensor is exposed to bright
sunlight or fluorescent lighting.
• Do not drop or bang.
• Do not leave in hot or humid locations.
• Do not allow it to get wet or place it on top of wet objects.
• Do not take apart.
• In rare cases, ambient conditions could impede the operation of the remote control. If this
happens, point the remote control at the main unit again, and repeat the operation.
■ Operating the remote
control
Point toward the projector's
infrared remote sensor, and press a
button on the remote control.
• Operating the projector from the front
Notes
• When you use for the first time after
purchase, a plastic sheet is provided
between the battery and its contact. Be
sure to remove by pulling it off.
• When operating the remote control from
behind the projector, the infrared beam
is reflected on the projecting surface and
may travel a shorter distance to reach
the projector depending on the shape
and material of the projecting surface.
20
Approx.15