Dimplex AC3CN Посібник користувача - Сторінка 5

Переглянути онлайн або завантажити pdf Посібник користувача для Обігрівач Dimplex AC3CN. Dimplex AC3CN 8 сторінок. Recessed ceiling heater/ over door heater
Також для Dimplex AC3CN: Інструкція (4 сторінок), Посібник користувача (4 сторінок)

Друкувати сторінку

WARNING: The Switch Panel should not be installed in a toilet or washroom.

The backing box (standard B.S. double gang as shown in Fig. 5) should be

ﬁ xed to a suitable wall. Suitable wall conduit should be used where applicable

to carry the cable between the heater and the switch panel. A suitable recessed

wall box may be substituted, as an alternative.

Installation of Heater

The Installation of this product must only be carried out by a prescribed

competent person in accordance with Building Regulations and the current IEE

Wiring Regulations for electrical equipment.

This heater can either be installed into a suspended or plasterboard ceiling.

First it is necessary to ensure that there is sufﬁ cient space above the ceiling

for the Installation of this product (see Fig. 1 and Fig. 7).

This product is designed to be suspended by threaded rod or wires/chains.

Always ensure this unit is adequately supported when installed.

Installation in a Ceiling

A hole as indicated in Fig. 1 and Fig. 6 must be cut into the ceiling. Allow an additional

amount for clearance. It may be necessary to ﬁ x an internal supporting frame

around the newly cut aperture in a plasterboard ceiling or suspended ceiling.

500mm

Fig

Fig. 1

Fig

Fig. 1

Fig

271mm

To mount the unit into the ceiling void, use lengths of threaded bar or hooks

(not supplied) screwed into the M8 threaded inserts located in the top side of

the heater (see Fig. 1 for dimensions). Adjust the height of the heater so the

inner edge of the grill surround is ﬂ ush with the ceiling.

400

Access Panel

275

265

Doorway

Fig. 7

2 3

120

Fig. 5

145

105mm

579mm

Installation in a Bulk Head

(over doorway)

A hole (579x271mm) as indicated in

Fig. 7, must be cut into the ceiling part

of the bulk head. Drop rods should be

used to mount the appliance in such a

position, as to have the base ﬂ ush with

the ceiling. An access panel should

also be provided on the front of the

bulkhead. This provides access to the

top of the appliance and cable entry

point. Access for wiring the appliance

is via the grille.

Operation of Switch Panel

Switch on electrical supply (MAINS IN)

to the Switch Panel.

Switching the switch marked 'I' (see '1' in Fig. 5) energises the fan and switches

on the electrical supply to the heater.

The heat selection switches allow heat settings to be chosen as shown

below:

Settings -

The desired setting can be obtained through switch selection.

WARNING

room temperature. Do not use this heater in small rooms when they

are occupied by persons not capable of leaving the room on their own,

unless constant supervision is provided.

This appliance is not intended for use by persons (including children)

with reduced physical, sensory or metal capabilities, or lack of

experience and knowledge, unless they have been given supervision or

instruction concerning use of the appliance by a person responsible for

their safety.

Children should be supervised to ensure that they do not play with the

appliance.

Fig. 6

Fan Only

I +

Fan +

Heat

I +

Fan + Full Heat

This heater is not equipped with a device to control the