CRP 80881 Посібник із швидкого старту - Сторінка 2

Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Іграшкова машинка на колесах CRP 80881. CRP 80881 2 сторінки.

Друкувати сторінку
NEW SOFTWARE
NEW LRP iX8 V2 TEAM SOFTWARE V2.7
MODE
Red LED
Yellow LED
Value
Blue LED
[Reverse]
0
1
2
3
4
5
6
White
Factory Settings
* Please see mode explanations for more details.
HOW TO GET INTO „MODE PROGRAMMING"
Press MODE button for at least 3sec.
• How to check the stored settings  Count the number of flashes of the blue SET-LED.
• How to change the settings  Press SET button to increase setting by one step.
• How to get to the next Mode  Press MODE button once.
• How to leave the programming mode  If last Mode is reached press the MODE button one more time. This will also store your settings.
RESET SPEED CONTROL TO FACTORY SETTINGS AFTER SOFTWARE UPDATE. MUST BE EXECUTED AFTER EACH SOFTWARE UPDATE!
Switch on the transmitter, then press and hold SET button while switching on the speed control. This will set speed control to factory default settings.
CALIBRATE SPEED CONTROL TO TRANSMITTER. MUST BE EXECUTED AFTER EACH SOFTWARE UPDATE!
Connect the speed-control to the battery and switch the unit on.
• Hold SET button pressed for at least 3sec.  You entered setup mode and SET LED flashes blue (it will flash until the setup is completed).
• Leave transmitter in neutral position and press SET button once.  Neutral setting is stored , MODE LED flashes yellow, SET LED flashes blue.
• Hold full throttle on transmitter and press SET button once.  Full-throttle setting is stored, MODE LED flashes red, SET LED flashes blue.
• Hold full brake on transmitter and press SET button once.  Brake setting is stored, LEDs glow red (MODE) and blue (SET).
HOW TO READ OUT THE MAXIMUM TEMPERATURE:
For speedo temperature, press and hold MODE button while switching on the speed control. Then release button.
Press MODE button again to change to motor temperature read-out.
For the temperature read-outs count the flashes of the blue LED to indicate „temperature till shutdown"
Blue LED
1
Temp. °C
> -45°C
Temp. °F
> -81°F
Note: In high temperature and high load conditions we recommend to cut the 4mm plugs and solder motor cables directly to the motor. You should
always check all connections that the connector plugs are tightly placed in power sockets. This protects your speedo from shutdowns and defects!
© 2017 LRP electronic GmbH
1
Drive Mode Profile
[Direction]
no
CCW
(normal)
yes
no
CW
(reverse)
yes
2
3
4
-40°C
-35°C
-30°C
-72°F
-63°F
-54°F
2
Same Time
Initial Drive
Power Profile
[%]
1
5
10
15
20
25
30
5
6
7
-25°C
-20°C
-15°C
-45°F
-36°F
-27°F
3
4
Alternate
Protection
[Value]
[-]
1
ALL
2
ESC
3
NONE*
4
5
6
7
8
9
10
-10°C
-5°C
Shutdown
-18°F
-9°F
Shutdown