CRU Dataport DE110 SCSI Посібник з інсталяції
Переглянути онлайн або завантажити pdf Посібник з інсталяції для Корпус CRU Dataport DE110 SCSI. CRU Dataport DE110 SCSI 2 сторінки. Ultra320 sca
Також для CRU Dataport DE110 SCSI: Посібник з інсталяції (2 сторінок)
Друкувати сторінку
DE110 Ultra320 SCA Install Guide
Removable Ultra320 Drive Enclosure
NOTES: DE110 Ultra320 receiving frames are indicated by their AMBER LED,
and the DE110 Ultra320 carriers are indicated by the Ultra320 logo.
For SCSI Ultra320 operation, the DE110 Ultra320 requires Ultra320 drives,
Ultra320 HBA, and Ultra320-compliant cabling (internal and external).
Receiving Frame Motherboard
I/O Connector (J3) - The input/output connector provides a standard
interface for all Ultra320 signals.
DC Power Connector (P1) - A standard 4-pin DC power connector is
used to accept DC power.
Option Pin Connector (W1)
Remote Unit ID Selection: Pins 1-8 of this connector are provided
for SCSI ID selection through a remote ID selector switch. Remote ID
selection requires that the unit ID switch located on the inside of the
receiving frame be set to "0" (onboard ID selection is set with a switch
located on the inside of the receiving frame as shown in Figure 4).
Factory-Installed Jumpers: There are two (2) jumpers factory-installed
on W1 (Pins 9 & 10 and 21 & 22). DO NOT remove these jumpers!
DC Power
68-Pin I/O
Connector (P1)
Connector (J3)
GND
= Pin 1
{
ID0
ID1
Remote ID Select
ID2
ID3
Figure 1: Receiving Frame Motherboard (Rear View)
Buzzer
Option Pin
Connector (W1)
Factory
Installed
Jumpers (do
not remove
Rugged, Reliable, Mobile, Secure
Installation
1. Carefully insert the drive into the carrier. Slide the drive to-
wards the Drive Carrier Board, so that the I/O connector on the
drive mates with the connector on the Drive Carrier Board. Turn
the drive/carrier assembly over.
2. Fasten the drive into place with four (4) #6-32 Phillips Flat
Head screws. Some drives may require minor adjustment
before securing into carrier with screws.
3. Install the provided drive cover.
Spacer Plates (optional)
The DE110 Ultra320 is designed to fit most computer systems
with standard 5.25" peripheral slots. The installation of the
spacer plates (provided) may or may not be necessary.
U320 Drive
(not included)
Ultra320
Logo
Drive
Carrier
Figure 2: Drive Installation Assembly
1-800-260-9800
1-800-260-9800
Drive Cover
(provided)
Drive Carrier Board
Spacer Plate*
(2 total)
*Note: Installation of Space
Plates is optional
#6-32 Phillips F. H. Screw
(6 total)
www.CRU-DataPort.com
www.CRU-DataPort.com
TM
Receiving
Frame