Aeon 60111 Посібник - Сторінка 2

Переглянути онлайн або завантажити pdf Посібник для Стелажі та підставки Aeon 60111. Aeon 60111 2 сторінки. Swiveling tv stand

Attach rubber feet (8) to

bottom of glass stand.

Note: Two people may be needed to hold parts

in place while tightening assembly.

A) Align parts on a flat surface per figure (3).

B) Insert two threaded rods (part C) through

parts shown in figure (3).

C) Tighten two screws (part A) until assembly is

tight using wrench (part R). Once tightened

properly the shelves should not be able to be

moved within the assembly. Do not over

tighten.

D) (Optional) Attach part (9) with screw (K)

using wrench (R). This is for wire management

on back of column.

Attach TV Bracket to Column Assembly

A) Stand up assembly from step (3) vertically.

B) Align plastic part (N) on TV bracket as seen in figure (4). Make

sure holes align.

C) Attach TV bracket in Figure (4) onto the two brackets shown in

figure (5). Tighten in two places with bolt (G), spacer (M) and nut (I).

Do not over tighten.

A) Carefully angle your TV against a wall with the back of the TV facing

you. Align the two vertical rails (part 7) with the screw holes on back of the

TV. Use appropriate screw size from included packet (see chart below).

B) Tighten screws until rails are tight. Do not over tighten. Use spacer

(part 5 in chart below) if the screw holes are recessed.

C) If needed, use square washer (part 6 in chart below).

Note: Make sure both rails are using same hole location to attach to

TV to ensure TV is level.

Washer