Aeon Labs Aeotec Heavy Duty Smart Switch Gen5 Посібник користувача - Сторінка 7
Переглянути онлайн або завантажити pdf Посібник користувача для Перемикач Aeon Labs Aeotec Heavy Duty Smart Switch Gen5. Aeon Labs Aeotec Heavy Duty Smart Switch Gen5 8 сторінок.
Друкувати сторінку11/22/2017
1. Place your gateway or controller into Z-Wave unpair or exclusion mode. (Please refer to your controller/gateway
manual on how to do this)
2. Press the Action Button on your Switch.
3. If your switch has been successfully unlinked to your network, its LED will begin to blink. If linking was unsuccessful,
the LED will return to its last LED state.
If you are using a Z-Stick:
1. If your Z-Stick is plugged into a gateway or a computer, unplug it.
2. Take your Z-Stick to your Heavy Duty Smart Switch.
3. Press the Action Button on your Z-Stick.
4. Press the Action Button on your Heavy Duty Smart Switch.
5. If your Heavy Duty Smart Switch has been successfully removed from your network, its Status LE D will blink. If the
removal was unsuccessful, its Status LED will not blink.
6. Press the Action Button on your Z-Stick to take it out of removal mode.
If you are using a Minimote:
1. Take your Minimote to your Heavy Duty Smart Switch.
2. Press the Remove Button on your Minimote.
3. Press the Action Button on your Heavy Duty Smart Switch.
4. If your Heavy Duty Smart Switch has been successfully removed from your network, its Status LED will blink. If the
removal was unsuccessful, its Status LED will not blink.
5. Press any button on your Minimote to take it out of removal mode.
Turn your Heavy Duty Smart Switch Gen5 on or off.
Your Heavy Duty Smart Switch can be turned on or off through the use of Z-Wave commands built into Z- Wave certified
controllers and gateways. The specific Z-Wave commands supporting this function are the Basic Command Class and
Binary Switch Command Class. Please consult the operation manual for your Z-Wave network controller for specific
instructions on controlling your Heavy Duty Smart Switch.
Monitoring power consumption.
Your Heavy Duty Smart Switch can report Watts energy usage or kWh energy usage to a Z-Wave gateway or controller. If
this function is supported by the gateway/controller, your energy consumption will be displayed within its user interface. The
specific Z-Wave commands supporting energy monitoring are the Meter Command Class and Multilevel Sensor Command
Class. Automatic reports go to association group 1, which is setup via the Association Command Class. Please consult
your gateway/controller manual for instructions on monitoring energy consumption through your Heavy Duty Smart Switch.
More advanced configurations.
The Smart Switch Gen5 has a longer list of device configurations that you can do with Smart Switch Gen5. These are not
exposed well in most gateways, but at the least you can manually set configurations through most Z-Wave gateways
available. These configuration options may not be available in a few gateways.
You can find the configuration sheet here: https://aeotec.freshdesk.com/helpdesk/attachments/6009584699
(https://aeotec.freshdesk.com/helpdesk/attachments/6009584699)
https://aeotec.freshdesk.com/support/solutions/articles/6000161813-heavy-duty-smart-switch-gen5-user-guide-
Heavy Duty Smart Switch Gen5 user guide. : Aeotec by Aeon Labs
7/8