Crux 14790 Інструкція з експлуатації - Сторінка 11

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Блендер Crux 14790. Crux 14790 20 сторінок. Cordless immersion blender

Charging Instructions

1. If the battery indicator (1) LED is display red, you must stop operating for recharging.

2. Press the release button (5), separate the blender shaft (6) from the appliance.

Insert the Main Body into the charge base (7).Then plug the charger into the power outlet.

(See Fig.4) The battery indicator will flashing red, when the battery indicator led shines

permanently red and don't flashing, It means the battery is fully charged.

3. After every usage, place the appliance back onto the charge base for recharging.

4. After charging, unplug the charger, remove the Main Body from the charge base,

and assemble the blender shaft and continute operating.

The batteries are protected against deep discharge. A completely discharged appliance has

to be charged for at least 15 minutes before it can be used for an appliance.

WARNING: The blender blade is very sharp, when Main Body is working, do not touch it.

CAUTION: Due to its design, this product is not suitable for prolonged use.

To avoid the handle becoming uncomfortably hot, use the product in short bursts

and allow to cool as necessary.

This appliance requires little maintenance. It contains no user-serviceable parts.

Any servicing requiring disassembly other than cleaning must be performed by a

qualified appliance repair technician.

Unplug the appliance and remove the detachable blending shaft or

whisking attachment.

2. Wash the detachable blending shaft or whisk attachments under running water, without

the use of abrasive cleaner or detergent. When finished cleaning the detachable

blending shaft or whisk attachment, place it upright so that any water that may have got

into, can drain out. The blending shaft is dishwasher safe; on top rack only.

NOTE: Do not soak the detachable blending shaft or whisk attachment in water for a long

period of time because overtime the lubrication on the bearings may wash away.

3. Wipe the motor housing and the charging base with a damp cloth. Never immerse

it in water for cleaning as electric shock may occur.

4. Dry thoroughly.