Aeon Labs Aeotec Посібник користувача - Сторінка 3
Переглянути онлайн або завантажити pdf Посібник користувача для Контролер Aeon Labs Aeotec. Aeon Labs Aeotec 7 сторінок. Home energy meter
Також для Aeon Labs Aeotec: Посібник користувача (11 сторінок), Посібник (9 сторінок)
Друкувати сторінку
10/19/2017
Panic Button can be used as a remote control within an existing Z-Wave network, or can act as the main controller for a Z-
Wave network that has no software controller or gateway.
To begin the setup process, you first need to insert Panic Button's battery.
1. Remove Panic Button's back cover by pressing Latch Release.
2. Insert the provided battery.
3. Replace the back cover.
From here, there are 2 different ways to set Panic Button up; adding Panic Button to an existing Z-Wave network, and
creating a new Z-Wave network with Panic button as the main controller. Those steps are elaborated in two separate
sections further in this guide. Please follow either of those 2 sections in this guide as desired.
If you already have an existing Z-Wave network (Panic Button as secondary
controller).
During the following steps, your Panic Button should be in close to your primary Z-Wave controller. This is likely to be a
gateway or hub.
1. Put your primary Z-Wave controller into inclusion mode. If you're unsure of how to do this, refer to the part of its user
manual that describes adding new Z-Wave devices to your network.
2. Press the Learn button on your Panic Button with the pin or press the bottom- right action button. Your Panic Button's
green light will begin to pulse.
3. When Panic Button successfully joins your Z-Wave network, its LED will flash green slowly 3 times and then quickly
flash green for 2 seconds before turning solid green for 2 seconds. Should the LED continue to flash green for 30
seconds before turning off, it has been unable to join your Z-Wave network; repeat the above steps and please contact
us for further support if needed.
Panic Button is now a part of your Z-Wave home control system.
It is possible for Panic Button to directly control a device or a group of devices without communicating via your Z-Wave
gateway. To directly control devices on or off, please follow the instructions in the "Create direct on / off control." section of
this guide. To directly control a group of devices without communicating via your Z-Wave gateway, your gateway must
support such Z-Wave's scene control functionality. Where we are aware of gateways that support such functionality, we
have noted it at http://support.aeotec.com/panicbutton/scene
controller not be noted, please contact your gateway or software maker's support desk for further information.
Please skip to the 'Change your remote's mode' section of this guide to continue.
If you need to create a new Z-Wave network.
https://aeotec.freshdesk.com/support/solutions/articles/6000177086-panic-button-user-manual-
Panic Button user manual. : Aeotec by Aeon Labs
(http://support.aeotec.com/panicbutton/scene)
Should your
3/7