Dimplex RLG25FC Посібник з експлуатації - Сторінка 16

Переглянути онлайн або завантажити pdf Посібник з експлуатації для Камінне приладдя Dimplex RLG25FC. Dimplex RLG25FC 18 сторінок. 25" electric log set
Також для Dimplex RLG25FC: Посібник користувача (14 сторінок)

Друкувати сторінку

Heater Assembly Replacement

Tools Required: Philips head screwdriver

Flat Head Screwdriver

WARNING: If the log grate was operating prior to ser-

vicing, allow at least 10 minutes for the heating elements to

cool off to avoid accidental burning of skin.

WARNING: Disconnect power before attempting any

maintenance to reduce the risk of electric shock or damage

to persons.

1. Lift the flame panel from the unit and put it aside in a

safe place.

2. Remove the ember mat by disconnecting it from the

right side of the unit.

3. Remove the 3 screws along the bottom of the front and

back of the bottom assembly and the four screws from

each corner on both ends. (Figure 4)

4. Gently tilt the unit onto the back and lower the bottom

assembly so that the electrcial can be easily accessed.

5. Remove the four screws in the top assembly - two on

either end of the heater.

6. Turn the logs and log grate on its side, to the right, to

access the four screws that secure the heater assem-

bly to the top assembly.

7. On the heater assembly, there is a plastic spacer that

channels the air from the heater assembly out of the

unit, remove the two screws on either end that hold the

plastic spacer to the heater. (Figure 9)

8. Install the plastic spacer to the new heater, transfer the

wires from the old heater to the new heater and re-as-

semble the remainder of the log grate in reverse order

from the instructions above.

NOTE: Use a flat head screwdriver to gently pry

between the end of the connector and the heater assem-

bly to release the wires.

WARNING: Ensure wires do not come in contact with

moving parts by securing wires in wiring tie wraps.

Figure 9

Plastic

Spacer

Connecting

Screws