DimSport My Tuning Bike Інструкція з експлуатації - Сторінка 2
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Аксесуари для мотоциклів DimSport My Tuning Bike. DimSport My Tuning Bike 6 сторінок. Device for permanent auto mapping function with bosch wideband o2 sensor
Друкувати сторінку
Check before installation:
No exhaust leaks (how to check: obstruct the exit of the exhaust pipe, if the engine turns on it means that
there are leaks).
No intake leaks
Clean air system (PAIR valve) blocked or removed.
The first column of the injection trim map is not modified by the My Tuning Bike so it's not possible to set
an AFR target.
My Tuning Bike works only with modules programmed with firmware:
1.0.30 or newer for Rapid Bike Evo
-
1.0.28 or newer for Rapid Bike Racing
-
The wideband O2 sensor is added to the standard configuration of the bike, it is not intended as a
replacement of the OEM O2 sensor:
The OEM O2 sensor CANNOT be removed;
The connection to the RapidBike Evo/Racing wiring must be carried out (if expected) in order to
allow the modulation of the O2 sensor signal;
Dimensione Sport s.r.l. accepts no responsibility in terms of bad operating of the vehicle if the OEM sensor is
removed.
1. Install the M 18x1,5mm steel bung on the exhaust before the catalytic converter (if present) and where
the multiple cylinders collect. If more My Tuning Bike must be installed it's recommended to install the
bung 15cm from the exhaust port on the respective cylinder you wish to tune.
The bung must be installed in a way that reduces the risk of moisture contamination on the sensor.
We suggest an inclination higher than 10° (see pict ure).
2. Connect the wiring F27-TERM1 to the Rapid Bike connector marked as CAN.
Issued by: PM
Installation
approved by DG
Warnings
WARNING
Rev.07
date 12/06/16
pag. 2/6