Pioneer AVH-P4200DVD Посібник з монтажу - Сторінка 2
Переглянути онлайн або завантажити pdf Посібник з монтажу для Автомобільний приймач Pioneer AVH-P4200DVD. Pioneer AVH-P4200DVD 40 сторінок. Dvd rds av receiver
Також для Pioneer AVH-P4200DVD: Посібник з монтажу (8 сторінок), Посібник із швидкого старту (2 сторінок)
Contents
Connecting the units ............................ 2
(AVH-P4200DVD/AVH-P3200DVD) ............. 4
Connecting the system (AVH-P3200BT) ......... 4
Connecting the power cord ............................ 6
sold power amp ........................................... 8
video component and the display ............ 10
rear video output ............................................10
Installation ........................................... 11
on the side of the unit ............................... 11
(AVH-P3200BT only) .................................. 12
on the sun visor ....................................................12
on the steering column .......................................12
Adjusting the microphone angle ...........................13
2
Connecting the units
WARNING
• To avoid the risk of accident and the potential
violation of applicable laws, no viewing of front
seat video should ever occur while the vehicle is
being driven. Also, rear displays should not be in
a location where they are visibly distracting to the
driver.
• In some countries or states the viewing of images
on a display inside a vehicle even by persons
other than the driver may be illegal. Where such
regulations apply, they must be obeyed and this
unit's DVD features should not be used.
CAUTION
• PIONEER does not recommend that you
install or service your display yourself.
Installing or servicing the product may
expose you to risk of electric shock or other
hazards. Refer all installation and servicing
of your display to authorized Pioneer service
personnel.
• Secure all wiring with cable clamps or
electrical tape. Do not allow any bare wiring
to remain exposed.
• Do not drill a hole into the engine
compartment to connect the yellow lead
of the unit to the vehicle battery. Engine
vibration may eventually cause the insulation
to fail at the point where the wire passes from
the passenger compartment into the engine
compartment. Take extra care in securing the
wire at this point.
• It is extremely dangerous to allow the display
lead to become wound around the steering
column or gearshift. Be sure to install the
display in such a way that it will not obstruct
driving.
• Make sure that wires will not interfere with
moving parts of the vehicle, such as the
gearshift, parking brake or seat sliding
mechanism.
• Do not shorten any leads. If you do, the
protection circuit may fail to work properly.
WARNING
LIGHT GREEN LEAD AT POWER CONNECTOR
IS DESIGNED TO DETECT PARKED STATUS
AND MUST BE CONNECTED TO THE POWER
SUPPLY SIDE OF THE PARKING BRAKE SWITCH.
IMPROPER CONNECTION OR USE OF THIS
LEAD MAY VIOLATE APPLICABLE LAW AND MAY
RESULT IN SERIOUS INJURY OR DAMAGE.