Pioneer AVH-P7600DVD Посібник з монтажу - Сторінка 14

Переглянути онлайн або завантажити pdf Посібник з монтажу для Автомобільний приймач Pioneer AVH-P7600DVD. Pioneer AVH-P7600DVD 34 сторінки. Owner's manual
Також для Pioneer AVH-P7600DVD: Посібник користувача (34 сторінок), Посібник з експлуатації (22 сторінок)

Друкувати сторінку

1. Connecting the System

Installation

Note:

• Before making a final installation of the unit,

temporarily connect the wiring to confirm that the

connections are correct and the system works

properly.

• Use only the parts included with the unit to

ensure proper installation. The use of unautho-

rized parts can cause malfunctions.

• Consult with your nearest dealer if installation

requires the drilling of holes or other modifica-

tions of the vehicle.

• Install the unit where it does not get in the dri-

ver's way and cannot injure the passenger if there

is a sudden stop, like an emergency stop.

• Do not place the display in a position where it

will impede the driver's visibility or affect the

operation of your vehicle's air bags.

• The semiconductor laser will be damaged if it

overheats, so don't install the unit anywhere hot

— for instance, near a heater outlet.

• If installation angle exceeds 30° from horizontal,

the unit might not give its optimum performance.

(Fig. 9)

• To ensure proper heat dissipation of this product,

take special care not to block the cooling fan side

of this product.

• When mounting the hide-away unit, make sure

none of the leads are trapped between the hide-

away unit and the surrounding metalwork or fit-

tings.

• Do not mount the hide-away unit near the heater

outlet, where it would be affected by heat, or near

the doors, where rainwater might splash onto it.

• Before drilling any mounting holes always check

behind where you want to drill the holes. Do not

drill into the gas line, brake line, electrical wiring

or other important parts.

• If the hide-away unit is installed in the passenger

compartment, anchor it securely so it does not

break free while the car is moving, and cause

injury or an accident.

• If the hide-away unit is installed under a front

seat, make sure it does not obstruct seat move-

ment. Route all leads and cords carefully around

the sliding mechanism so they do not get caught

or pinched in the mechanism and cause a short

circuit.

Installing the hide-away unit

Mounting with Velcro Tape

Thoroughly wipe off the surface

before affixing the velcro tape.

30°

Fig. 9

Hide-away unit

Velcro tape

(large) (hard)

Velcro tape

(large) (soft)

Car mat or chassis

Fig. 10