Pioneer CDX-M1026ZG Посібник з експлуатації - Сторінка 33

Переглянути онлайн або завантажити pdf Посібник з експлуатації для Автомобільний приймач Pioneer CDX-M1026ZG. Pioneer CDX-M1026ZG 45 сторінок. Multi-compact disc player

Друкувати сторінку

6.3 CHECKING THE GRATING

- Checking the Grating After Changing the Pickup Unit

•Note :

Unlike previous CD mechanism modules the grating angle of the pickup unit cannot be adjusted after the pickup

unit is changed. The pickup unit in the CD mechanism module is adjusted on the production line to match the CD

mechanism module and is thus the best adjusted pickup unit for the CD mechanism module. Changing the pickup

unit is thus best considered as a last resort. However, if the pickup unit must be changed, the grating should be

checked using the procedure below.

•Purpose :

To check that the grating is within an acceptable range.

•Symptoms of Mal-adjustment :

If the grating is off by a large amount symptoms such as being unable to close tracking, being unable to perform

track search operations, or track searching taking a long time, may appear.

•Method :

•Measuring Equipment

•Measuring Points

•Disc

•Mode

CD CORE UNIT

•Checking Procedure

1. In test mode, load the disc and switch the 5V regulator on.

2. Using the TR+ and TR- buttons, move the pickup unit to the innermost track.

3. Press key 5 to close focus, the display should read "91". Press key 4 to implement the tracking balance adjust-

ment the display should now read "81". Press key 5 4 times. The display will change, returning to "81" on the

fourth press.

4. As shown in the diagram above, monitor the LPF outputs using the oscilloscope and check that the phase differ-

ence is within 75° . Refer to the photographs supplied to determine the phase angle.

5. If the phase difference is determined to be greater than 75° try changing the pickup unit to see if there is any

improvement. If, after trying this a number of times, the grating angle does not become less than 75° then the

mechanism should be judged to be at fault.

•Note

Because of eccentricity in the disc and a slight misalignment of the clamping center the grating waveform may be

seen to "wobble" ( the phase difference changes as the disc rotates). The angle specified above indicates the aver-

age angle.

•Hint

Reloading the disc changes the clamp position and may decrease the "wobble".

•Oscilloscope, Two L.P.F.

•E, F, REFOUT

•ABEX TCD-784

•TEST MODE

L.P.F.

100kW

REFO

390pF

REFO

100kW

390pF

REFO

CDX-M1026ZG

Ych

Xch

Oscilloscope

L.P.F.