Pioneer DEH P4100UB Посібник з монтажу

Переглянути онлайн або завантажити pdf Посібник з монтажу для Автомобільний приймач Pioneer DEH P4100UB. Pioneer DEH P4100UB 5 сторінок. Cd receiver

Друкувати сторінку

CD RECEIVER

AUTORADIO CD

RADIO CD

DEH-P4100UB

Installation Manual

Manuel d'installation

Manual de instalación

Printed in China

Imprimé en Chine

<YRD5262-A/S> UC

Installation

English

2. Secure the mounting sleeve by

Note

using a screwdriver to bend the

• Check all connections and systems before final

metal tabs (90°) into place.

installation.

Mounting sleeve

• Do not use unauthorized parts. The use of

Dashboard

unauthorized parts may cause malfunctions.

• Consult with your dealer if installation requires

182

drilling of holes or other modifications of the

vehicle.

• Do not install this unit where:

— it may interfere with operation of the vehicle.

— it may cause injury to a passenger as a result

of a sudden stop.

• The semiconductor laser will be damaged if it

3. Install the unit.

overheats. Install this unit away from hot places

• Use commercially available parts when

such as near the heater outlet.

installing.

• Optimum performance is obtained when the unit

is installed at an angle of less than 60°.

Nut

Filrewall or

60°

metal support

Metal strap

Screw

DIN Front/Rear-mount

This unit can be properly installed either from

Screw (M4 8)

"Front" (conventional DIN Front-mount) or

"Rear" (DIN Rear-mount installation, utilizing

threaded screw holes at the sides of unit

chassis). For details, refer to the following

installation methods.

• Make sure that the unit is installed securely

DIN Front-mount

in place. Unstable installation may cause this

unit to malfunction, such as sound skip.

Installation with metal strap and

Removing the Unit

screws

1. Extend top and bottom of the trim

1. Insert the mounting sleeve into the

ring outwards to remove the trim

dashboard.

ring. When reattaching the trim

• When installing in a shallow space, use a

ring, push the trim ring onto the

supplied mounting sleeve. If there is enough

space behind the unit, use factory supplied

unit until it clicks. (If the trim ring

mounting sleeve.

is attached upside down, the trim

ring will not fit properly.)

• It becomes easy to remove the trim ring if the

front panel is released.

Trim ring

Installation

English

2. Insert the supplied extraction keys

3. Tighten two screws on each side.

• Use either truss screws (5 mm × 8 mm)

into both sides of the unit until

or flush surface screws (5 mm × 9 mm),

they click into place.

depending on the shape of screw holes in the

bracket.

Screw

Dashboard or Console

Factory radio mounting bracket

3. Pull the unit out of the dashboard.

Fastening the front panel

DIN Rear-mount

If you do not plan to detach the front panel,

the front panel can be fastened with supplied

1. Extend top and bottom of the trim

screw.

ring outwards to remove the trim

ring. When reattaching the trim ring,

push the trim ring onto the unit until

it clicks. (If the trim ring is attached

upside down, the trim ring will not

fit properly.)

Screw

• It becomes easy to remove the trim ring if the

front panel is released.

Trim ring

2. Determine the appropriate position

where the holes on the bracket and

the side of the unit match.