Pioneer DEH P4800MP Посібник з експлуатації - Сторінка 5
Переглянути онлайн або завантажити pdf Посібник з експлуатації для Автомобільний приймач Pioneer DEH P4800MP. Pioneer DEH P4800MP 36 сторінок. Multi-cd control high power cd/mp3/wma player with rds tuner
Друкувати сторінку
MAN-DEH-P4800MP-GB.fm Page 5 Thursday, September 29, 2005 11:55 AM
Installation
Notes
• Before making a final installation of the unit, temporarily connect the wiring to confirm that
the connections are correct and the system works properly.
• Use only the parts included with the unit to ensure proper installation. The use of
unauthorized parts can cause malfunctions.
• Consult with your nearest dealer if installation requires the drilling of holes or other
modifications of the vehicle.
• Install the unit where it does not get in the driver's way and cannot injure the passenger if
there is a sudden stop, like an emergency stop.
• The semiconductor laser will be damaged if it overheats, so don't install the unit anywhere
hot – for instance, near a heater outlet.
• If installation angle exceeds 60° from horizontal, the unit might not give its optimum
performance.
60°
DIN Front/Rear-mount
This unit can be properly installed either from "Front" (conventional DIN Front-mount)
or "Rear" (DIN Rear-mount installation, utilizing threaded screw holes at the sides of
unit chassis). For details, refer to the following illustrated installation methods.
DIN Front-mount
Installation with the rubber bush
Holder
After inserting the holder into the dashboard, then select
Dashboard
the appropriate tabs according to the thickness of the
dashboard material and bend them.
(Install as firmly as possible using the top and bottom
tabs. To secure, bend the tabs 90 degrees.)
Rubber bush
Screw
Removing the Unit
To remove the frame, extend top and bottom of the frame outwards in order to unlock
it. (When reattaching the frame, point the side with a groove downwards and attach it.)
• It becomes easy to remove the frame if the front panel is released.
Insert the supplied extraction keys into the unit, as shown
in the figure, until they click into place. Keeping the keys
pressed against the sides of the unit, pull the unit out.
DIN Rear-mount
Installation using the screw holes on the side of the unit
1. Remove the frame.
To remove the frame, extend top and bottom of the frame outwards in order to unlock
it. (When reattaching the frame, point the side with a groove downwards and attach it.)
• It becomes easy to remove the frame if the front panel is released.
5