Pioneer DEH-4490BT Посібник користувача - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник користувача для Автомобільний приймач Pioneer DEH-4490BT. Pioneer DEH-4490BT 25 сторінок. Cd rds receiver

Друкувати сторінку

Section

Operating this unit

Removing the front panel to protect your unit from

theft

1 Press the detach button to release the front

panel.

2 Push the front panel upward (M) and then pull

it toward (N) you.

3 Always keep the detached front panel in a pro-

tection device such as a protection case.

Re-attaching the front panel

1 Slide the front panel to the left.

Make sure to insert the tabs on the left side of

the head unit into the slots on the front panel.

2 Press the right side of the front panel until it is

firmly seated.

If you cannot attach the front panel to the

head unit successfully, make sure that you are

placing the front panel onto the head unit cor-

rectly. Forcing the front panel into place may

result in damage to the front panel or head

unit.

Turning the unit on

1 Press SRC/OFF to turn the unit on.

Turning the unit off

1 Press and hold SRC/OFF until the unit turns

off.

Selecting a source

1 Press SRC/OFF to cycle between:

TUNER (tuner)—CD (built-in CD player)—USB

(USB)/iPod (iPod)—AUX (AUX)—BT AUDIO

(Bluetooth audio)

Adjusting the volume

1 Turn M.C. to adjust the volume.

WARNING

For safety reasons, park your vehicle when re-

moving the front panel.

Note

When this unit's blue/white lead is connected to

the vehicle's auto-antenna relay control termi-

nal, the vehicle's antenna extends when this

unit's source is turned on. To retract the anten-

na, turn the source off.

Use and care of the remote

control

Using the remote control

1 Point the remote control in the direction of the

front panel to operate.

When using for the first time, pull out the film

protruding from the tray.

Replacing the battery

1 Slide the tray out on the back of the remote

control.

2 Insert the battery with the plus (+) and minus

(–) poles aligned properly.

Operating this unit

WARNING

! Keep the battery out of the reach of children.

Should the battery be swallowed, consult a

doctor immediately.

! Batteries (battery pack or batteries installed)

must not be exposed to excessive heat such

as sunshine, fire or the like.

CAUTION

! Use one CR2025 (3 V) lithium battery.

! Remove the battery if the remote control is

not used for a month or longer.

! There is a danger of explosion if the battery is

incorrectly replaced. Replace only with the

same or equivalent type.

! Do not handle the battery with metallic tools.

! Do not store the battery with metallic ob-

jects.

! If the battery leaks, wipe the remote control

completely clean and install a new battery.

! When disposing of used batteries, comply

with governmental regulations or environ-

mental public institutions' rules that apply in

your country/area.

Important

! Do not store the remote control in high tem-

peratures or direct sunlight.

! The remote control may not function properly

in direct sunlight.

! Do not let the remote control fall onto the

floor, where it may become jammed under

the brake or accelerator pedal.

Using Bluetooth telephone

Important

! Since this unit is on standby to connect with

your cellular phone via Bluetooth wireless

technology, using it without the engine run-

ning can drain the battery power.

! Operations may vary depending on the kind

of cellular phone.

! Advanced operations that require attention

such as dialing numbers on the monitor,

using the phone book, etc., are prohibited

while driving. Park your vehicle in a safe

place when using these advanced opera-

tions.

Setting up for hands-free phoning

Before you can use the hands-free phoning

function you must set up the unit for use with

your cellular phone.

1 Connection

Operate the Bluetooth telephone connection

menu. Refer to Connection menu operation on

page 8.

2 Function settings

Operate the Bluetooth telephone function

menu. Refer to Phone menu operation on page

10.

Basic operations

Making a phone call

1 Refer to Phone menu operation on page 10.

Answering an incoming call

1 When a call is received, press M.C.

Ending a call

1 Press

Rejecting an incoming call

1 When a call is received, press

Answering a call waiting

1 When a call is received, press M.C.

Switching between callers on hold

1 Press M.C.

Canceling call waiting

1 Press