Pioneer DEH-P3000IB Посібник з монтажу

Переглянути онлайн або завантажити pdf Посібник з монтажу для Автомобільний приймач Pioneer DEH-P3000IB. Pioneer DEH-P3000IB 7 сторінок. Pioneer deh-p3000ib: install guide
Також для Pioneer DEH-P3000IB: Посібник з монтажу (4 сторінок), Посібник з експлуатації (20 сторінок)

Друкувати сторінку

DEH-P3000IB

Printed in China

<CRD4249-A/S> ES

Installation

English

3. Install the unit as illustrated.

Note

• Check all connections and systems before final

Mounting sleeve

Dashboard

installation.

• Do not use unauthorized parts. The use of

182

1 1 1 82

unauthorized parts may cause malfunctions.

• Consult with your dealer if installation requires

Rubber bush

drilling of holes or other modifications of the

vehicle.

• Do not install this unit where:

Screw

— it may interfere with operation of the vehicle.

— it may cause injury to a passenger as a result

of a sudden stop.

• The semiconductor laser will be damaged if it

overheats. Install this unit away from hot places

such as near the heater outlet.

Removing the Unit

• Optimum performance is obtained when the unit is

1. Extend top and bottom of the trim

installed at an angle of less than 60°.

ring outwards to remove the trim

ring. When reattaching the trim ring,

60°

push the trim ring onto the unit until

it clicks. (If the trim ring is attached

upside down, the trim ring will not

• When installing, to ensure proper heat dispersal

fit properly.)

when using this unit, make sure you leave ample

• It becomes easy to remove the trim ring if the

space behind the rear panel and wrap any loose

front panel is released.

cables so they are not blocking the vents.

DIN Front/Rear-mount

Trim ring

This unit can be properly installed either from

"Front" (conventional DIN Front-mount) or

"Rear" (DIN Rear-mount installation, utilizing

threaded screw holes at the sides of unit

chassis). For details, refer to the following

installation methods.

2. Insert the supplied extraction keys

DIN Front-mount

into both sides of the unit until

they click into place.

Installation with the rubber bush

1. Insert the mounting sleeve into the

dashboard.

• When installing in a shallow space, use a

supplied mounting sleeve. If there is enough

space behind the unit, use factory supplied

mounting sleeve.

2. Secure the mounting sleeve by

using a screwdriver to bend the

metal tabs (90°) into place.

3. Pull the unit out of the dashboard.

Installation

English

DIN Rear-mount

1. Extend top and bottom of the trim

ring outwards to remove the trim

ring. When reattaching the trim ring,

push the trim ring onto the unit until

it clicks. (If the trim ring is attached

upside down, the trim ring will not

fit properly.)

• It becomes easy to remove the trim ring if the

front panel is released.

Trim ring

2. Determine the appropriate position

where the holes on the bracket and

the side of the unit match.

3. Tighten two screws on each side.

• Use either truss screws (5 mm × 8 mm)

or flush surface screws (5 mm × 9 mm),

depending on the shape of screw holes in the

bracket.

Screw

Dashboard or Console

Factory radio mounting bracket