Pioneer Super Tuner IIID DEH-4250SD Посібник з монтажу
Переглянути онлайн або завантажити pdf Посібник з монтажу для Автомобільний приймач Pioneer Super Tuner IIID DEH-4250SD. Pioneer Super Tuner IIID DEH-4250SD 8 сторінок. Cd receiver
Також для Pioneer Super Tuner IIID DEH-4250SD: Посібник з експлуатації (23 сторінок)
Друкувати сторінку
CD RECEIVER
RADIO CD
CD PLAYER
DEH-4250SD
Installation Manual
Manual de instalación
Manual de instalação
Printed in Thailand
<CRD4437-A/N> ES
<KMINX> <09H00000>
Installation
English
2. Secure the mounting sleeve by
Note
using a screwdriver to bend the
• Check all connections and systems before final
metal tabs (90°) into place.
installation.
• Do not use unauthorized parts. The use of
Dashboard
unauthorized parts may cause malfunctions.
• Consult with your dealer if installation requires
drilling of holes or other modifications of the
vehicle.
• Do not install this unit where:
— it may interfere with operation of the vehicle.
— it may cause injury to a passenger as a result
of a sudden stop.
• The semiconductor laser will be damaged if it
overheats. Install this unit away from hot places
such as near the heater outlet.
• Optimum performance is obtained when the unit is
Mounting sleeve
installed at an angle of less than 60°.
60°
3. Install the unit as illustrated.
Use commercially available parts when
installing.
• When installing, to ensure proper heat dispersal
Nut
when using this unit, make sure you leave ample
space behind the rear panel and wrap any loose
Firewall or
cables so they are not blocking the vents.
metal support
DIN front/rear mount
Metal strap
Screw
This unit can be properly installed either from
"Front" (conventional DIN front-mount) or
"Rear" (DIN rear-mount installation, utilizing
threaded screw holes on the sides of unit
Screw (M4 8)
chassis). For details, refer to the following
installation methods.
DIN Front-mount
1. Insert the mounting sleeve into the
• Make sure that the unit is installed securely
dashboard.
in place. An unstable installation may cause
For installation in shallow spaces, use the
skipping or other malfunctions.
supplied mounting sleeve. If there is enough
space, use the mounting sleeve that came with
the vehicle.
Installation
English
DIN Rear-mount
3. Pull the unit out of the dashboard.
1. Determine the appropriate position
where the holes on the bracket and
the side of the unit match.
2. Tighten two screws on each side.
Truss screw (5 mm × 8 mm)
Mounting bracket
Dashboard or Console
Removing the unit
1. Extend top and bottom of the trim
ring outwards to remove the trim
ring. (When reattaching the trim
ring, point the side with the groove
down.)
Trim ring
• Releasing the front panel allows easier access
to the trim ring.
2. Insert the supplied extraction keys
into both sides of the unit until
they click into place.