Pioneer XC-L7 Інструкція з експлуатації Посібник з експлуатації - Сторінка 8

Переглянути онлайн або завантажити pdf Інструкція з експлуатації Посібник з експлуатації для Автомобільний приймач Pioneer XC-L7. Pioneer XC-L7 50 сторінок. Stereo cd receiver/stereo cassette deck/ speaker system

Друкувати сторінку

Satellite speaker

CONNECTING THE SPEAKERS

AND POWER CORDS

) Connect the speaker cords to the SPEAKER

terminals. (Satellite Speaker S-L7-LR/

S-L7-A-LR)

Connect the white cords (with gray line) to the "+"

(red) terminais and the white cords to the "—" (black)

terminals.

Connect the cords to the speakers in nearly the

same way.

@ Twist the

wire strands.

@ Push away the @) Pull back the

tab. Be sure

to tighten the

cords firmly.

tab and insert

the cord into

the terminal.

NOTE:

Do not allow the conductors of the cords to project

out of the terminals or to come into contact with other

conductors. A breakdown or failure may occur when

conductors touch.

Speaker impedance

Connect speaker systems with a nominal impedance

ranging from 6 Q to 16 © (4 Q in the case of sub-woof-

ers).

Precautions for the S-L7-LR/S-L7-A-LR and S-L7-W/

S-L7-A-W

Do not connect to any amplifier other than the one

supplied with this system. Connection to any other

amplifier may in rare cases result in smoke or fire.

Becareful not to block the port opening on the front

panel of the speaker.

8 | <ARB7126>

Satellite speaker

Bevery careful when connecting speaker cords! !f

one of the satellite speakers is mistakenly con-

nected to the subwoofer's speaker cord and con-

nector, the satellite speaker may be damaged.

@ This speaker system is not magnetically shielded,

and may cause

color noise or distortion when

placed very near a television. If this occurs, place

the speakers farther away from the television set.

@ Connect the speaker cords to the speaker

terminals (SUBWOOFER S-L7-W/S-L7-A-W)}

QQ) Align the cord's socket properly with the termi-

nal and insert into the receptacle. To release the

socket, pinch the top and bottom halves and pull

out.

@ On the end of the cord not provided with a

socket, twist the insulation tips and pull off, ex-

posing the wire.

@) Press down the tabs and insert the cords' wire

tips fully into the connectors.

@) Press up on the connector tabs, returning them

to their original positions, and confirm that the

cords are firmly fixed in place.

Dark Gray