Pioneer DEH-8350SD Посібник користувача - Сторінка 12

Переглянути онлайн або завантажити pdf Посібник користувача для Приймач Pioneer DEH-8350SD. Pioneer DEH-8350SD 20 сторінок. Cd rds receiver

Друкувати сторінку

Section

Installation

j When using a subwoofer of 70 W (2 Ω), be

sure to connect the subwoofer to the violet

and violet/black leads of this unit. Do not

connect anything to the green and green/

black leads.

k Not used.

l Subwoofer (4 Ω)× 2

Notes

! With a 2 speaker system, do not connect any-

thing to the speaker leads that are not con-

nected to speakers.

! Change the initial setting of this unit. Refer

to S/W control (rear output and subwoofer

setting) on page 10.

The subwoofer output of this unit is monau-

ral.

Power amp (sold separately)

Perform these connections when using the op-

tional amplifier.













1 System remote control

Connect to Blue/white cable.

2 Power amp (sold separately)

3 Connect with RCA cables (sold separately)

4 To Rear output

5 Rear speaker

6 To Front output

7 Front speaker

8 To subwoofer output

9 Subwoofer

Installation

Important

! Check all connections and systems before

final installation.

! Do not use unauthorized parts as this may

cause malfunctions.

! Consult your dealer if installation requires

drilling of holes or other modifications to the

vehicle.

! Do not install this unit where:

— it may interfere with operation of the vehicle.

— it may cause injury to a passenger as a result

of a sudden stop.

! The semiconductor laser will be damaged if

it overheats. Install this unit away from hot

places such as near the heater outlet.

! Optimum performance is obtained when the

unit is installed at an angle of less than 60°.

60°

! To ensure proper heat dispersal when using

this unit, make sure you leave ample space

behind the rear panel and wrap any loose ca-

bles so they are not blocking the vents when

installing the unit.

DIN front/rear mount

This unit can be properly installed using either

front-mount or rear-mount installation.

Use commercially available parts when instal-

ling.

Installation

DIN Front-mount

Insert the mounting sleeve into the dash-

board.

For installation in shallow spaces, use the sup-

plied mounting sleeve. If there is enough space,

use the mounting sleeve that came with the ve-

hicle.

Secure the mounting sleeve by using a

screwdriver to bend the metal tabs (90°) into

place.

1 Dashboard

2 Mounting sleeve

Install the unit as illustrated.

1 Nut

2 Firewall or metal support

3 Metal strap

4 Screw

5 Screw (M4 × 8)

# Make sure that the unit is installed securely in

place. An unstable installation may cause skipping

or other malfunctions.

DIN Rear-mount

Determine the appropriate position

where the holes on the bracket and the side

of the unit match.

Tighten two screws on each side.

1 Truss screw (5 mm × 8 mm)

2 Mounting bracket

3 Dashboard or console

Removing the unit

Remove the trim ring.

1 Trim ring

2 Notched tab

! Releasing the front panel allows easier ac-

cess to the trim ring.

! When reattaching the trim ring, point the

side with the notched tab down.

Insert the supplied extraction keys into

both sides of the unit until they click into

place.