Ariston AWD 121 Інструкція з монтажу та використання - Сторінка 15

Переглянути онлайн або завантажити pdf Інструкція з монтажу та використання для Пральна машина Ariston AWD 121. Ariston AWD 121 17 сторінок. Washer / washer-dryer combo
Також для Ariston AWD 121: Інструкція користувача (21 сторінок), Посібник з ремонту (20 сторінок)

Друкувати сторінку

Ariston AWD 121 Інструкція з монтажу та використання

The washer-dryer

does not drain or

spin.

Does the selected program

incorporate water drai-

ning? Some programs stop

at the end of the wash cycle

and draining will have to be

selected manually.

Is the "Easy iron" function

-where provided - enabled?

This

function

requires

manual

selection

draining.

Is the drain pump clogged?

To check it, turn off the water

supply, unplug the washer-

dryer

and

instructions on page 18, or

call technical support.

Always get

assistance from

authorized service

agent and always

insist on original

spare parts.

Cleaning Filters

Remove filters

using tweezers,

clean and replace

Drain: to avoid flooding

be careful to the adjust the drain

hose to at least

25" above the base

of the appliance.

Fasten the hoses securely.

www.aristonappliances.us

Is the drain hose kinked?

The drain hose must be as

straight as possible. Make

sure the drain hose is not

crimped or kinked.

Is the washer-dryer's drain

hose clogged? Is there an

extension of the drain hose?

If so, is it positioned

incorrectly, blocking the

water flow?

for

Excessive vibration

during the spin cycle.

the

Have all shipping bolts

been removed during

installation?

following

page

installation procedures.

Has the washer-dryer been

levelled correctly? The

levelling of the appliance

should

periodically. Adjust the feet

and check them with a level.

Remove

filters, clean

and replace

Tape

Is there space between the

machine and adjacent

units? If it is not a built-in

model, the washer-dryer will

oscillate a bit during the spin

cycle. A few cm of space

should therefore be left

around it.

The washer-dryer

leaks.

Is the metal ring of the inlet

hose properly attached?

Turn off the water supply,

unplug the appliance and try

tightening its attachment

without forcing it.

See

the

Is the detergent dispenser

obstructed? Remove and

wash it under tap water.

Is the drain hose well

attached? Turn off the water

supply,

checked

appliance and try tightening

its attachment.

Tape

Too much foam.

Is the detergent appropriate

for machine washing? Check

whether the definition on its

label reads "for machine wash"

or "hand and machine wash",

or any other similar wording.

Is the correct amount being

used? An excessive amount of

detergent, besides producing

too much foam, does not

guarantee a more effective

wash, and causes scaling in the

internal parts of the appliance.

The washer-dryer

does not dry.

Check whether:

the plug has been correctly

inserted into the socket; there

is electricity in your home; the

appliance door has been shut

properly; a delayed start (if

available) has not been

unplug

the

selected; program knob A

has been set to Reset and

the drying cycle knob C has

been

0 minutes.

The washer-dryer doesn't

dry properly.

Check whether:

1) the end of the drain hose

is underwater; 2) the drain

pump is obstructed; 3) the

advice given on the maxi-

mum loads has been taken;

4) the water tap has been

turned on.

If, despite all checks, the

washer-dryer fails to function

and the problem persists, call

your

nearest

Customer Service Centre,

1-800-426-0825 providing the

following information:

Tape

- the nature of malfunction

- the model type no. (Mod. ....)

- the serial number (S/N ....)

This information can be found

on the data plate situated at the

back of the washer-dryer.

Instructions for installation and use

set

position

authorized