Pioneer VSX-5400 Інструкція з експлуатації Посібник з експлуатації - Сторінка 17
Переглянути онлайн або завантажити pdf Інструкція з експлуатації Посібник з експлуатації для Стерео приймач Pioneer VSX-5400. Pioneer VSX-5400 47 сторінок. Audio/video stereo receiver
Також для Pioneer VSX-5400: Посібник з експлуатації (37 сторінок)
Друкувати сторінку
FRONT PANEL FACILITIES
(a FM MODE AUTO/MONO selector switch
Monaural mode:
When receiving distant stations or stations with weak broadcast signals,
the input signal may be weak, thus resulting in increased noise during
FM stereo broadcasts. In this event, setting the receiver to the monaural
mode will reduce the noise. in this case, however, FM stereo broadcasts
will be reproduced in monaural sound.
NOTE:
This switch has no effect on reception of AM broadcasts.
TUNING switches
: Performs tuning from the currently displayed station frequency in
ascending frequency order.
-— : Performs tuning in order to descending frequencies.
(2 REAR LEVEL (-, +) switches
Operate only when the surround mode is on.
These switches are used to preset the sound level difference between
the front and surround speakers. In this way, after presetting the
difference, the overall volume of the front and surround speakers can
be changed using the MASTER VOLUME control, while still maintaining
the sound volume differential.
: Surround speaker volume is reduced.
+:
Surround speaker volume is increased.
Press
~ and + together to restore front and surround to the default
valume balance setting.
Example: if keep pressing the '+' switch.
(3 RETURN switch
Pressing this switch returns the receiver to the following settings, the
sound level being controlled by the MASTER VOLUME control knob.
* TAPE 2 (MONITOR)
OFF
*® SURROUND MODE.
+. OFF
® MUTING ...02.. eo.
+. OFF
* FRONT BALANCE
* FUNCTION...
* STATION CALL.
. CENTER
TUNER
..
1CH*
* When
a station is not memorized
in 1 CH, station search
will
automatically proceed from the frequency displayed.
NOTE:
ue
After pressing the RETURN switch, if there is no sound even when the
MASTER VOLUME knob is adjusted, confirm that the SPEAKERS switch
#5 ON.
(® MUTING switch
Press to temporarily cut off the sound volume. The display section
MUTING indicator will flash. When pressed again, the sound will return
to its previous level,
@ BALANCE switches
Use to adjust the sound volume balance between left and right speakers.
L: Press to decrease the sound on the right side.
R: Press to decrease the sound on the left side.
Press L and R together to bring the volume balance back to center.
NOTE:
The left-right sound volume balance cannot be adjusted independently
on the front and surround rear speakers.
Example: If keep pressing the "R'' switch.
MASTER VOLUME control
Use to simultaneously adjust the sound volume from the front and
surround speakers.
@ SPLIT SCREEN contro!
This control allows you to freely control the area of enhanced picture
{on right side of screen) and original picture (non-enhanced, on left side
of screen) by means of a vertical line dividing the screen into two
sections.
Screen to which
Screen to which
enhancer has been
enhancer has not
applied |
been applied
Ral
| | ii
[ wee
|
SPLIT SCREEN
SPLIT SCREEN
SPLIT SCREEN
=
B&O
eo
ae
Ce
ca
NOTE:
This fine is not output from the VCR (VCR 7 and VCR 2} VIDEO OUT
Jacks. As a result, the split screen image is not recorded; the recorded
image will be entirely that produced by the enhancer function.
ENHANCER control
When performing tape copying with a VCR, some deterioration in image
quality occurs normally. This contral allows compensation
for this
detericration in image quality by emphasizing image detail.
NOTE:
The ENHANCER control functions to suppress image deterioration, but
will not improve image quality beyond its original state.
VIDEO ENHANCER switch
Turns the built-in video enhancer on and off. When it is ON, the
ENHANCER control can be used to sharpen the playback video image.
Using the SPLIT SCREEN function will enable you to compare the
enhanced and original {unenhanced} images.
17
<ARB1174>