Pioneer VSX-9700S Інструкція з експлуатації Посібник з експлуатації - Сторінка 42
Переглянути онлайн або завантажити pdf Інструкція з експлуатації Посібник з експлуатації для Стерео приймач Pioneer VSX-9700S. Pioneer VSX-9700S 48 сторінок.
Друкувати сторінкуREMOTE CONTROL
PROGRAMMING
Leagan Y
© TRANSMIT
ipso
auDIae®
© @ AUX
TADE/VER
T
oo
—_
—
vor
cH
covor
amo &
@) LEARN indicator
This indicator lights when the Learn function is activated.
ON: Learning is possible.
OFF: Regular remote control functions can be performed.
NOTE: If the LEARN indicator flashes, this indicates that the program
capacity is exceeded and that the last command is not memorized.
@ LEARN selector switch
This can be set as follows:
LEARN:
This position is used for storing the codes of your remote control unit.
USE:
Set to this position after codes have been stored in the LEARN position.
(Set to this position when using memorized commands.)
SR RECALL:
Set to this position when transmitting Pioneer unified remote control
code signals (Marked on the remote control unit).
42
<ARB1234>
[Operation example}
1. Set the LEARN switch of the programmable remote control unit to
the LEARN position and set the TRANSMIT mode selector switch
to the VIDEO position.
© Programming
is possible with the TRANSMIT
mode selector
switch in any position, but VIDEO is used as an example.
2. Place the transmission sections of the programmable remote control
unit and the remote contro! of the VCR facing each other.
1 to 2 inches
© Place the two units on a table, separated by 2 to 5 crn (1 to 2
inches).
Memorization will not be possible if they are too close.
3. Hold down the VCR PLAY key of the Programmable remote control
unit until the LEARN indicator light up, then release the key.
4. Hold down the PLAY key of the VCR remote control unit.
5. Release the key of the VCR remote control unit after making sure
that the LEARN indicator has gone out on the Pioneer remote control
unit.
NOTE:
If the LEARN indicator flashes, it indicates that you are trying to
preset a key not available for the learning function, or otherwise the
program capacity has been exceeded, the function prograrmmed last
will not be memorized
correctly.
All previously
programmed
' functions, however, will be retained in memory and may be used as
they are if the last function is not essential. For re-programming refer
to page 43 "'Returning to the Initial Settings. ''
6. Set the LEARN selector switch of the programmable remote control
unit to the USE position.
© The previous code (Pioneer uniform remote control code or code
for other equipment) is erased and replaced by the new code.
7. Check that the program works.
© Try actual operation and make sure the unit works properly.
© If the VCR does not operate when pressing the key, change angle,
position and distance between the remote contro! units and repeat
the programming procedure.
© When programming, make sure that the function indications (for
example, > , >,
§§) on the other remote control unit and the
programmable remote control unit are the same. This wil facilitate
operation.
NOTE:
Be careful when using the learn function because signals from the
transmitting remote control unit may be reflected from walls or the
ceiling, and may arrive at the sensor of a component other than the
programmable remote control unit. It's a good idea to remove the tape
from a cassette deck or VCR in case they are accidentally gctivated.
It is also preferable to unplug the power cords of system coriponents
from power outlets, or cover the remote sensors of remotecontrolled
components to prevent accidental operation.
1
|