Pioneer VSX-D498 Інструкція з експлуатації Посібник з експлуатації - Сторінка 24

Переглянути онлайн або завантажити pdf Інструкція з експлуатації Посібник з експлуатації для Стерео приймач Pioneer VSX-D498. Pioneer VSX-D498 48 сторінок. Audio/video multi-channel receiver

Друкувати сторінку

Names of Parts and Basic Operations

! SIGNAL SELECT button

Use to select input signals for the digital components.

First press DVD/LD, TV/SAT, MD/TAPE 1, CD or VCR

(& Function buttons) to select the component, then

press SIGNAL SELECT repeatedly to select one of the

following:

ANALOG : Selects the analog (R and L) audio signals.

DIGITAL : Selects the digital audio signals. This

receiver automatically detects and displays the

format of the signal being input. AC-3 lights when

Dolby Digital signals are input. (Dolby Digital

decoding is switched automatically.)

• SIGNAL SELECT is fixed in the "ANALOG" position

for components not assigned to one of the three

digital input jacks.

• Because the audio from a karaoke microphone and

LD recorded with analog audio only is not output

from the digital output, set SIGNAL SELECT to

"ANALOG".

• This receiver can only play back Dolby Digital, PCM

(32kHz, 44kHz, and 48kHz),digital signal formats.

With digital signal formats other than these, set

SIGNAL SELECT to "ANALOG".

@ DSP MODE button

Press repeatedly to select a DSP sound mode (HALL 1,

HALL 2, JAZZ, DANCE, THEATER 1, or THEATER 2).

Use these modes to produce surround sound from

standard (two channel) stereo sources.

# MIDNIGHT button

Press to hear effective surround sound at low volume

levels. The effect is automatically adjusted according

to the volume level.

$ MASTER VOLUME

After turning on the desired component, rotate to

adjust the volume.

% PHONES jack

Connect headphones for private listening (the

speakers turn off automatically).

^ STATION/FREQUENCY (+/–) button

STATION: Press to select the preset channel.

FREQUENCY: Press to select the frequency.

& Function buttons

Selects the function. Each press switches the DVD/LD

input between DVD/LD and DVD 5.1 channel.

* TAPE 2 MONITOR button

Switches the TAPE 2 monitor on or off (refer to page 36).

( DIRECT button

Switches direct playback on or off. Use to bypass the

receiver's tone control circuitry or level control for

higher fidelity to the program source. When DIRECT

is ON, Dolby, DSP, LOUDNESS and MIDNIGHT mode

are automatically turned OFF.

) VIDEO INPUT jacks

Connect a video camera, video game system, etc. to

the VIDEO INPUT jacks (refer to page 10).