Pioneer VSX-D510 Інструкція з експлуатації Посібник з експлуатації - Сторінка 31
Переглянути онлайн або завантажити pdf Інструкція з експлуатації Посібник з експлуатації для Стерео приймач Pioneer VSX-D510. Pioneer VSX-D510 40 сторінок. Audio/video multi-channel receiver
Також для Pioneer VSX-D510: Інструкція з експлуатації Посібник з експлуатації (36 сторінок), Посібник з експлуатації (14 сторінок)
Друкувати сторінку
Controlling the Rest of Your System
Setting Up the Remote Control
Recalling preset codes
The following steps show you how to recall preset codes
for each
MULTI CONTROL
is assigned, pressing the button will automatically set the
remote to operate the respective component.
MEMO:
• Refer to "Preset Code List" on pages 35-37 for the
components and manufacturers available.
• Refer to "Controlling the Rest of Your System" on
pages 33-34 for detailed explanations on how to
operate your other components.
MULTI CONTROL
DVD/LD TV/SAT VCR/DVR
CD-R/
RECEIVER TUNER
TAPE/MD
1
2
DSP MODE MIDNIGHT 5.1CH
1
2
CHANNEL
TEST
SELECT
TONE
ATT
5
6
CHANNEL
LEVEL
9
0
FUNC
TV CONTROL
VOL
FQ
ST
ENTER
MENU
FQ
SOURCE CLASS
MPX
7
8
D.ACCESS
DISPLAY RF ATT
1
¡
4
LOUDNESS FUNCTION MUTING
FL
REMOTE
RECEIVER
DIMMER
SETUP
AUDIO/VIDEO PRE-PROGRAMMED
REMOTE CONTROL UNIT
button. Once the preset code
Î
LED
CD
2
TV CONT
3
3
4
SIGNAL
SELECT
7
8
EFFECT
10
DISC
CH
VOL
ST
TOP
MENU
BAND
3
CHANNEL
¢
MASTER
1,4
VOLUME
1 Press
REMOTE SET UP
time to select the preset mode.
The LED on the remote control starts to blink.
To cancel the preset mode at any time
Press
.
REMOTE SET UP
2 Press the
MULTI CONTROL
component you want to control.
Each button can be set to control one of the following
components
: DVD or LD player
DVD/LD
: TV or Satellite tuner
TV/SAT
: VCR or Digital Video Recorder
VCR/DVR
: CD player
CD
: CD Recorder or Tape deck or MD player
CD-R/TAPE/MD
: TV or Cable TV tuner
TV CONT
The LED lights steadily.
3 Point the remote control toward the
component to be controlled, enter the 3 digit
preset code.
When you enter the preset code, the remote control
emits a power ON/OFF signal. If the component
turns ON or OFF , you have entered the proper code.
If the component does not turn ON or OFF and there
is more than one preset code, try inputting another
code (starting again from step 2).
Some manufacturers use several sets of remote
control signals and the first code may not correspond
to your component.
Repeat steps 2 through 3 to recall preset codes for
as many components as necessary.
4 Press
REMOTE SET UP
mode.
The remote control returns to the previous operation
mode.
MEMO
• When operating a Pioneer DVD/LD player, set the
preset code to "
" in the preset mode.
111
• TUNER cannot be preset.
and
at the same
1
button for the
to exit the preset
09
31
En