Pioneer A-351R Інструкція з експлуатації Посібник з експлуатації - Сторінка 8
Переглянути онлайн або завантажити pdf Інструкція з експлуатації Посібник з експлуатації для Підсилювач Pioneer A-351R. Pioneer A-351R 13 сторінок.
Друкувати сторінку
OPERATIONS
BEFORE BEGINNING OPERATIONS
1. Set the POWER STANDBY/ON switch to ON.
2. Press the SPEAKERS selector button corresponding
to the speaker system to be used.
3. Set the DIRECT button to off.
PLAYBACK PROCEDURES
1. Set the INPUT SELECTOR
buttons to the desired
playback source.
¢ For playback with the equipment connected to LINE terminals:
Set to [LINE].
© For reception of an AM/FM broadcast: Set to [TUNER].
© For playback of a record: Set to [PHONO].
¢ For playback of a compact disc: Set to [CD].
¢ For playback of a tape: Set to [TAPE 1/DAT].
NOTE:
Always be sure to turn off TAPE 2/ADPT when not using TAPE 2/
ADPT.
. Operate the equipment to begin playback.
. Adjust playback volume with VOLUME CONTROL on
this unit.
4. Adjust the tone to your preference using BASS and
TREBLE controls, and BALANCE control.
PLAYBACK USING A GRAPHIC EQUALIZER
The sound of all sources can be finely adjusted with a graphic equalizer
connected to TAPE 2/ADPT terminals.
After pressing the TAPE 2/ADPT button so that its indicator lights, select
the source that you wish to play.
However, the graphic equalizer is bypassed when DIRECT button is on.
NOTE:
Be sure to perform this operation with the adaptor component power
switch in the on position. Even when not using the adaptor component,
its power switch must be left on. If the adaptor component is switched
off, no sound will be produced, or the playback sound will be distorted.
WN
RECORDING TAPES
1. Select
the
recording
equipment
with
INPUT
SELECTOR buttons.
2. Begin recording by operating the recording equipment.
Refer to the operating instructions for your cassette deck for proper
operating procedures.
USING AN AUDIO TIMER TO PERFORM TIMER
RECORDING
Connect this unit's power cord into the AC power outlet of an audio
timer, and set the POWER STANDBY/ON switch to the ON condition
(STANDBY indicator goes off) when making timer settings.
If the unit is left in the standby mode (STANDBY indicator lights), timer
operation will not be possible.
8
<ARB1355>
I
COPYING TAPES
When two decks are used {or when using double cassette deck), you
can record the sounds from one deck onto the other.
Application examples:
* To make a tape copy with contents identical to the original tape.
© To edit a recording of an FM broadcast in order to cut out unwanted
commercials, recording only desired material onto another tape.
When using two cassette decks
1: Load tapes for playback
(pre-recorded
tape) and
recording (blank tape) into the respective cassette
decks.
2. Select the copying direction with INPUT SELECTOR
buttons.
e When copying from the cassette deck of TAPE 1/DAT terminals
to the cassette deck of TAPE 2/ADPT terminals: Press the INPUT
SELECTOR button [TAPE 1/DAT].
e When copying from the cassette deck of TAPE 2/ADPT terminals
to the cassette deck of TAPE 1/DAT terminals: Press the INPUT
SELECTOR
button [TAPE 2/ADPT].
Set INPUT SELECTOR
to
anything except TAPE 1/DAT.
3. Operate the cassette decks to begin copying.
Set the cassette deck with the blank tape to the recording mode,
and set the cassette deck with the original (playback) tape to the
playback mode.