Pioneer A-403 Інструкція з експлуатації Посібник з експлуатації - Сторінка 9

Переглянути онлайн або завантажити pdf Інструкція з експлуатації Посібник з експлуатації для Підсилювач Pioneer A-403. Pioneer A-403 12 сторінок.

Друкувати сторінку

OPERATIONS

COPYING TAPES

When two decks are used, you can record the sounds from one deck

onto the other.

Application examples:

®To make a tape copy with contents identical to the original tape.

® To edit a recording of an FM broadcast in order to cut out unwanted

commercials,

recording only of desired

material onto another

tape.

When using two cassette decks

1. Load tapes for playback (pre-recorded tape) and

recording

(blank

tape)

into

the

respective

cassette decks.

2. Select the copying direction with input selector

buttons and TAPE 2 MONITOR button.

@ When copying from the cassette deck of TAPE 1/DAT terminals

to the cassette deck of the TAPE 2/MONITOR (ADPT) terminals:

Set the Input selector button to TAPE

1/DAT

and TAPE

MONITOR button to OFF.

® When copying from the cassette deck of the TAPE 2/MONITOR

(ADPT) terminals to the cassette deck of TAPE 1/DAT terminals:

Set the TAPE 2 MONITOR button to ON and the Input selector to

a position other then TAPE 1/DAT.

Operate the cassette decks to begin copying.

Set the cassette deck with the pre-recorded tape to the playback

mode. Set the cassette deck with the blank tape to the recording

mode.

TO USE THE COMPONENT CONNECTED TO THE TAPE 2 MONITOR (ADPT) TERMINALS

[For an adaptor component]

By connecting a graphic equalizer, source sounds (from records,

tapes, AM/FM broadcasts, etc.) can be heard with added sound and

tone compensation.

Sounds compensated via the adaptor component can be recorded

(TAPE 1 REC terminals).

1. Set the TAPE 2 MONITOR button to ON.

2. Play back the source.

3. Operate the adaptor component.

[For a cassette deck]

A cassette deck connected here can be operated in the same way

{recording

and playback)

as a deck connected

to the TAPE

MONITOR (ADPT) terminals.

Also, if two decks are used, you can copy tapes from one deck onto

the other (see the section "COPYING TAPES")

1. Set the TAPE 2 MONITOR button to ON.

2. Operate the cassette deck to perform playback

{or recording).

NOTE:

days even when the Power switch is set to off or the power cord is

unplugged.

After this period, the CD is automatically selected when the power

fs supplied.

® Be sure to perform this operation with the adaptor component

power switch in the on position.

Even when not using the adaptor

component,

its power switch must be left an. If the adaptor

component is switched off, ne sound will be produced, or the

playback sound wilf be distorted.