Pioneer SA-1060 Інструкція з експлуатації Посібник з експлуатації - Сторінка 7

Переглянути онлайн або завантажити pdf Інструкція з експлуатації Посібник з експлуатації для Підсилювач Pioneer SA-1060. Pioneer SA-1060 11 сторінок.

Друкувати сторінку
OPERATIONS
BEFORE BEGINNING
OPERATIONS
Set the controls and switches as follows:
Set the SPEAKERS A switch to ON.
Virdee
eee)
Set the SUBSONIC filter switch
to OFF.
Set the BALANCE control
to the center position.
OPERATION
PROCEDURES
(1) Turn on power to this unit and to the other
equipment to be used.
(2) Press the FUNCTION
switch
Use to select playback source.
e
When listening to a record: Press [PHONO].
©
When listening to an AM or FM broadcast: Press [TUNER].
¢
When listening to a tape: Press [TAPE 1].
¢
When listening to programs from equipment connected to
the CD/VIDEO terminals: Press [CD/VIDEO].
(3) Operate equipment to begin playback.
(4) Adjust playback volume with the VOLUME
control on this unit.
NOTE:
When
playing
back
records
with
coarse
grooves,
super-low-
frequency noise may cause cross-modulation distortion, resulting in
distored sound and possible damage to speakers.
In this event, setting the
SUBSONIC filter switch to [ON] will allow
you to eliminate super-low-frequency noise (15 Hz and below).
(1)
(2)
Porrerertacry
(4)
Set the ADAPTOR/TAPE 2 switch to OFF.
TO USE THE COMPONENT
CONNECTED
TO
THE
ADAPTOR/TAPE
2 TERMINALS:
{For an adaptor component]
By connecting
a graphic
equalizer,
source
sounds
(from
records, tapes, AM/FM
broadcasts, etc.) can be heard with
added sound and tone compensation.
(1) Play back the source.
(2) Set the ADAPTOR/TAPE
2 switch to ON.
(3) Operate the adaptor component.
[For a tape deck]
A tape deck connected here can be operated in the same way
(recording and playback) as a deck connected to the TAPE 1
terminals. Also, if two decks are used, you can copy tapes
from one deck onto the other (see the section
'Copying
Tapes").
(1) Set the ADAPTOR/TAPE
2 switch to ON.
(2) Operate the tape deck to perform playback (or
recording).
———
ADAPTOR/TAPE 2 switch
RECORDING
TAPES:
e
While listening to playback on equipment connected to the
rear panel terminals , you can record these same sounds on
tape merely by setting your tape deck to the recording
mode.
¢
When
recording sounds modified by an adaptor compo-
nent, set the ADAPTOR/TAPE 2 switch to ON.
°
Refer to the operating instructions for your tape deck for
proper operating procedures.
( ADAPTOR/TAPE 2 switch }