Pioneer SA-610 Посібник з експлуатації - Сторінка 5

Переглянути онлайн або завантажити pdf Посібник з експлуатації для Підсилювач Pioneer SA-610. Pioneer SA-610 24 сторінки.

Друкувати сторінку

O volurvrE coNTRoL

Use this control to adjust the output level to the speakers

and headphones. Turn it clockwise to increase the output

l e v e l . N o s o u n d w i l l b e h e a r d i f y o u s e t i t t o , , 0 . , '

@ n CR op H o N E JA c K

Plug the headphones into this jack when you want to

listen through your stereo headphones.

NOTE:

Set the speaker selector to OFF when listening only with head-

phones.

€ ) su e s oN t c F T L T E R S W T T C H

When this switch is set to the 'l 5Hz position, the subsonic

filter with a cut-off frequency of 15Hz is actuated. The

subsonic filter serves to attenuate frequencies lower than

15Hz in a 6dB/oct slope. lt is therefore effective in

suppressing ultra-low-frequency noise which is generated

by record warp and other causes. You cannot actually

hear this noise but it is a factor in the generation of

intermodulation distortion and it may damage your

speaker system. Set this switch to the 1SHz position

during record play for the best effect.

@ rorue swtrcH

Set this switch to ON when adjusting the bass and treble

controls. When set to the upper (OFF) position, the tone

control circuits are disengaged and frequency response is

flat. This function is convenient for checking phono car-

tridge and speaker tone quality and listening room

acoustics.

@ powen tNDtcAToR

When the power switch is set to ON this lamp lights up,

i n d i c a t i n g t h e a m p l i f i e r i s t u r n e d o n .

sA-Ci1cl

@ LouolrrEss swtrcH

When listening to a performance with the volume control

turned down, set this switch to ON and the bass and

treble will be accentuated.

W h e n t h e v o l u m e i s l o w , t h e h u m a n e a r f i n d s i t h a r d e r

to hear the bass and treble than when the volume is high.

The loudness switch is thus designed to compensate for

this deficiency. By setting it to ON, the bass and treble

come through much more strongly and the sound takes on

a punch even when the volume control is turned down.

@ rnpe 2 swrTcH

Set this switch to the ON position when monitoring a tape

performance on a tape deck which you have connected to

t h e T A P E 2 j a c k s o r w h e n m o n i t o r i n g a r e c o r d i n g .

NOTE:

Set the switch to the upper (OFF) position when tistening to

records or broadcasts, etc. selected by the function selector.

@ BalarucE coNTRoL

Use this control to balance the volume of the left and

r i g h t c h a n n e l s . l f t h e s o u n d a p p e a r s t o b e l o u d e r o n t h e

r i g h t , i t m e a n s t h a t t h e v o l u m e o f t h e r i g h t c h a n n e l i s

higher. Turn the balance control to the left and adjust.

Conversely, if the sound appears to be louder on the left,

it means that the volume of the left channel is higher.

Therefore, turn the balance control to the right and

adjust.