Pioneer SX-201 Інструкція з експлуатації Посібник з експлуатації - Сторінка 11
Переглянути онлайн або завантажити pdf Інструкція з експлуатації Посібник з експлуатації для Підсилювач Pioneer SX-201. Pioneer SX-201 17 сторінок. Stereo control amplifier
Також для Pioneer SX-201: Інструкція з експлуатації Посібник з експлуатації (28 сторінок)
Друкувати сторінку
DIRECT ACCESS TUNING
3.4
5
When you know the frequency of the desired station, the frequen-
cy can be input directly using the STATION CALL (number) but-
tons in the following way:
1. Press the POWER switch to the ON position.
NOTE
Be sure to turn the TAPE 2 MONITOR button OFF when listening
to AM or FM broadcasts.
2. Select either FM or AM using the BAND selector
button.
3. Press the DIRECT ACCESS tuning button.
® In the Direct Access tuning mode, the DIRECT ACCESS tuning
indicator will light up.
® If you do not perform any operations within five seconds of
pressing the DIRECT ACCESS
button, direct access is can-
celed,
4. Input
the desired
station
frequency
using
the
STATION CALL buttons.
Example 1: To receive FM 106.00 MHz
DIRECT ACCESS tuning indicator lights up.
DIRECT
ACCESS
MHz
=]
Press the DIRECT
ACCESS tuning
button.
—
1 ~
Mix
Press the button *1
g Nby
HAIN
L inst
MHz
s
oe
uN
"7IN
=p
|
|
Press the button *0
Press the button *6
Press the button *O
FOR MULTI-VOLTAGE
MODEL
® When the CHANNEL
STEP switch is set to FM 100 KHz step,
the tuning operation is completed and reception begins.
-
-
)
f
i
¢
2
|
LI nite
When the CHANNEL STEP switch is set to FM 50 kHz step:
rnc
lz
pm 1 LE LL Ly Qe
Se
|
'6
Press the button #0
y
"0
!
LL sae
Press the button *O
|
)
Once the station frequency has been input, the receiver tunes in
that frequency.
if the input frequency falls below the lower or
higher limit of the receiver's receivable frequency range (FM:
87.5 MHz
—
108 MHz;
AM:
530 kHz
—
1,700 kHz (10 kHz
step), 531 kHz — 1,602 kHz (9kHz step) "LOWER" or "UPPER" is
displayed, indicating that the frequency which has been input can-
not be tuned in.
5. Adjust the volume with the VOLUME control and
the tone with the GRAPHIC EQUALIZER controls.
To cancel frequency input
Direct access is canceled when the DIRECT ACCESS tuning but-
ton is pressed again.
Under the following conditions direct access is canceled and the
unit returns to the condition in effect before direct access was
selected: TD
If there is no key input for about five seconds after the DIRECT
ACCESS tuning button was pressed.
°2
if more than about eight seconds elapse between number input.
]
10
<ARB1357>