Pioneer VSA-1000 Інструкція з експлуатації Посібник з експлуатації - Сторінка 10
Переглянути онлайн або завантажити pdf Інструкція з експлуатації Посібник з експлуатації для Підсилювач Pioneer VSA-1000. Pioneer VSA-1000 35 сторінок. Av digital surround amplifier
Також для Pioneer VSA-1000: Інструкція з експлуатації Посібник з експлуатації (35 сторінок)
Друкувати сторінку
* Illustration shows
U.S. model.
@,9|O.O|O@
RR
af
MRED
©|O,O|O@O
REESE SETA)
i @-R-O
@ PRE AMP OUT jacks
When using a power amplifier to boost the volume of front, rear or center
speakers, connect here. Refer to page 16 for details concerning
connection. Connect the power cord of the power amplifier to the AC
OUTLETS (SWITCHED) of this unit.
NOTE:
Pay attention to the power consumption of the power amplifier used.
For more details refer to @® AC OUTLETS on page 11.
@ POWER AMP IN jacks
When a preamplifier (optional) is used with the VSA-1000 power
amplifier to drive the front, rear or center speakers, use these jacks.
Refer to page 16 for details concerning connection.
z
First switch the preamplifier power ON, and then switch the VSA-1000
power ON.
NOTE:
When not using, be sure to connect the PRE AMP OUT and the POWER
AMP IN with a connector bar.
@
VIDEO OUT TO RF MODULATOR jack
Use this when connecting a TV set that doesn't have a video input jack.
When performing connections, the RF MODULATOR JA-RF5 (sold
separately) is required. By connecting an RF modulator, video signal can
be converted to VHF signal (U.S. channel 3 or 4), thus allowing this
unit to be used to view the selected source on a TV set.
@ CENTER SPEAKER terminals
Use to connect a surround center channel speaker system.
Connect a speaker system having a nominal impedance ranging from
80 to 160.
10
<ARB1177>
@
O®
® VIDEO ADAPTOR IN/OUT jacks
Use to connect a video adaptor component such as a video enhancer
or color corrector.
© VIDEO OUT jacks
Connect to a monitor TV video input jack.
If the monitor TV has an S-VIDEO input, and a VDP or VCR is connected
to the VSA-1000 with an S-VIDEO connector, the S-VIDEO connector
can also be used.
There are 2 sets of video output jacks so 2 monitors can be used at
the same time if you wish.
@ VDP jacks
Connect here to the output jacks of a Videodisc player.
It is also possible to connect to the S-VIDEO connector if the VDP has
an S-VIDEO output.
@® VCR 1 IN/OUT jacks
IN:
Connect to VCR output (video/audio) jacks.
OUT:
Connect to the VCR input (video/audio) jacks.
¢ If the VCR has S-VIDEO input/output connectors the S-VIDEO
connectors can also be used.
© If the audio input/output of the VCR is monaural, connect to VCR 1
either of the L or R jacks and set the VCR 1 MODE switch to the
MONO
position.
@© VCR 2 IN/OUT jacks
Connect to the second VCR input/output jacks.
«If the VCR has S-VIDEO input/output connectors, it can also be
connected to the S-VIDEO connectors.